print/muttprint
Matthias Apitz
guru at unixarea.de
Sat Oct 11 15:40:07 UTC 2014
El día Saturday, October 11, 2014 a las 05:20:16PM +0200, Kurt Jaeger escribió:
Hi,
I have removed Lukas Ruf <Lukas.Ruf at lpr.ch> from the thread because he
said to me that he does not use FreeBSD since ~1995.
> mat@ mailed that
>
> USE_TEX=latex dvipsk
>
> should be used instead of the two additional run_deps.
A side note:
bapt switched from 'latex' to texlive:
------------------------------------------------------------------------
r350369 | bapt | 2014-04-06 17:42:15 +0200 (dom 06 de abr de 2014) | 3
líneas
Support stage
Switch from latex to texlive
>
> Can you test if this works in your use-case and report the results ?
>
and yes, when you compile the port directly with
# make install
'USE_TEX= texlive' pulls in
Tex, but it does not if you compile the ports with poudriere. I broough
this question up in freebsd-pkg@ but did not got any comments on this.
I can revoke the change in my VM / poudriere and send in a complete log
of the compilation of print/muttprint if someone is willing to dig into.
For the moment, I have not found any other solution as the two
additional lines.
Thx
matthias
--
Matthias Apitz | /"\ ASCII Ribbon Campaign:
E-mail: guru at unixarea.de | \ / - No HTML/RTF in E-mail
WWW: http://www.unixarea.de/ | X - No proprietary attachments
phone: +49-170-4527211 | / \ - Respect for open standards
| en.wikipedia.org/wiki/ASCII_Ribbon_Campaign
More information about the freebsd-ports
mailing list