Device polling heavy traffic
Freebsd-lists at daveg.ca
Freebsd-lists at daveg.ca
Tue Dec 27 10:18:09 PST 2005
>>>>> "Mihai" == Mihai Tanasescu <mihai at duras.ro> writes:
Mihai> Hello, I'm running the following setup:
Mihai> Freebsd Dual Xeon 3Ghz machine (SMP enabled)
Mihai> 3 x 100 Mbits/s links (used at 80% capacity) - 3 x Intel 100
Mihai> 1 x 1000 Gbit link to a cisco router (transfers downstream the
Mihai> other 3 links) - 1 x Intel em
Mihai> I'm getting something arround 100k pkt/sec input and 100k
Mihai> pkt/sec output as "systat -ip 1" shows.
Mihai> Kernel polling is enabled. I have tried options HZ=1000,
Mihai> options HZ=2500 to see if anything changes.
Mihai> The problem: If I ping this machine or anything that is routed
Mihai> through it I get response times of 10-15-30 ms and once in 30
Mihai> seconds a packet is lost.
Mihai> If I disable kernel.polling.enable then I get response times of
Mihai> 1-2-3 ms but I also get a lot of interrupts and a kernel panic
Mihai> after about 20 min.
We've done a bunch of different experiments on various hardware and
various operating systems. 300 kpps of very small packets is about
the forwarding limit of FreeBSD ... with any hardware we can find. So
if your packets are non-trivial ... there is a lesser cost to packet
size than packet number ... then 200kpps will likely show some loss
due to FreeBSD's inability to forward more packets.
Keep in mind that I've had two engineers spend months on this with
some guidance from me.
Now a stock linux on the same hardware can handle about 500 kpps, but
there's a caveat. Linux hashes packet streams (key of sce ip,
src port, dest ip, dest port) for both routed and terminated traffic.
This hash has some advantages, but has a huge drawback. If you spray
more than than the hash size worth of streams at the linux box (even
if it's not routing), then it basically falls over.
(not quite... packet performance goes from 500 kpps to less than
10kpps and everything is hosed until it stops. Profiling shows it
spends 99% of it's time in the hash emptying and allocaing code)
This means that a few megabit of fully random small packets will knock
over an arbitrary linux box. Every time.
Not even SCO boxes are that lame (hah... :)
My current thinking is that the hardware model has to change to get
better performance. I'm not really a hardware guy (hardware is evil),
but as I understand it, we're approaching limits of PCI busses.
One thing that might improve the performance of your box is to swap
out the FXP's for EM's. Even at 100 megabit, the EM's are measurably
more efficient at passing traffic. FXP's are no slouch (although,
like em's, there's dozens of different kinds with differing
performance characteristics), but EM's are better. The EM driver
seems better at polling, too.
|David Gilbert, Independent Contractor. | Two things can be |
|Mail: dave at daveg.ca | equal if and only if they |
|http://daveg.ca | are precisely opposite. |
More information about the freebsd-performance