[D800] Dell D800 (FBSD 5.2-release) Broadcom BCM5705M MTU/Jumbo Problem

[David Gilbert]

>>>>> "Eric" == Eric Anderson <anderson at centtech.com> writes:

Eric> As a data point, my BCM5702 (Dell D600) works fine: # ifconfig
Eric> -a bge0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu
Eric> 9000 options=1b<RXCSUM,TXCSUM,VLAN_MTU,VLAN_HWTAGGING> inet6
Eric> fe80::20b:dbff:fea3:f9a1%bge0 prefixlen 64 scopeid 0x1 inet
Eric> 0.0.0.0 netmask 0xff000000 broadcast 255.255.255.255 ether
Eric> 00:0b:db:a3:f9:a1 media: Ethernet autoselect (none) status: no
Eric> carrier

What is the probe line for your bge?

Mine is:

bge0: <Broadcom BCM5705M Gigabit Ethernet, ASIC rev. 0x3001> mem 0xfaff0000-0xfaffffff irq 11 at device 0.0 on pci2
bge0: Ethernet address: 00:0b:db:94:3d:01
miibus0: <MII bus> on bge0

Dave.

-- 
============================================================================
|David Gilbert, Independent Contractor.       | Two things can only be     |
|Mail:       dave at daveg.ca                    |  equal if and only if they |
|http://daveg.ca                              |   are precisely opposite.  |
=========================================================GLO================