Lots of input errors...

[Shawn Ramsey]

> Hello:
>
> Judging from your output I would say two things:
>
> 1) You have a bad cable.  CRC and framing errors are usually a result of
bad
> media.
> 2) You should set the port to auto/auto, not 100/Full hard set, unless you
> have specifically set that up in rc.conf.  If one side is hard set and the
> other is set to auto, you will see lots of runts because of a duplex
> mismatch.  I think the RFC states you have to go to half duplex if you are
> autosensing and the other side doesn't respond, which is the case if it's
> hard set.

Ok.. It is set hard to 100BT/FD on both ends. I don't know if you saw this,
but since resetting the stats a few hours ago, it shows no errors at all on
their end, but were still getting errors on our end... The CRC and frame
errors could have been from a media mismatch when things were first setup.
Im not sure if the stats have ever been reset. Assuming the errors stay at
zero on their end, any ideas? Am going to try another server/router, and if
things look better, start replacing hardware on this router...