FreeBSD with SDR-3.0 can't assign request address

[s4412038 at psu.ac.th]

Dear Sir

      I'v installed SDR-3.0 package on FreeBSD-4.9 (I don’t compile
from source)
Because I use with IPv6 address. Everything sound good during the
installation.
But when I call sdr with my hostname (v6node1) as follow:
        # sdr v6node1

The error as below

    1. setsockopt - IP_ADD_MEMBERSHIP: Can't assign requested address
       bus send: No route to host

    2. setsockopt - IP_ADD_MEMBERSHIP: Can't assign requested address
       sd_listen: setsockopt IP_ADD_MEMBERSHIP err, addr: 224.2.127.254

      My network configuration as below

fxp0: flags=8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> mtu 1500
	inet6 fe80::220:edff:fe59:5540%fxp0 prefixlen 64 scopeid 0x1
	inet6 3ffe:b80:53:1c6:220:edff:fe59:5540 prefixlen 64 autoconf
	inet 172.30.130.242 netmask 0xfffff000 broadcast 172.30.143.255
	ether 00:20:ed:59:55:40
	media: Ethernet autoselect (100baseTX)
	status: active
lp0: flags=8810<POINTOPOINT,SIMPLEX,MULTICAST> mtu 1500
lo0: flags=8049<UP,LOOPBACK,RUNNING,MULTICAST> mtu 16384
	inet6 ::1 prefixlen 128
	inet6 fe80::1%lo0 prefixlen 64 scopeid 0x3
	inet 127.0.0.1 netmask 0xff000000
ppp0: flags=8010<POINTOPOINT,MULTICAST> mtu 1500
sl0: flags=c010<POINTOPOINT,LINK2,MULTICAST> mtu 552
faith0: flags=8002<BROADCAST,MULTICAST> mtu 1500

        And I have already added myhostname (v6node1) and IPv4/6 address
in /etc/hosts.

        v6node1 has been configured address by dhcp then default route
of v4 and v6 network has been automatically assigned. But the first error
is still being there.

        I use IPv6 multicast address rather than IPv4. I'v already
installed VIC program and it works fine with IPv6. But SDR can not be run.

        Please suggest me.

Thank you
Maneenate:>



-----------------------------------------
This email was sent using SquirrelMail.
https://front.psu.ac.th/