AR7161 USB

[Adrian Chadd]

it could be something to do with port or phy power. check the default
gpio settings for your board; some don't enable usb phy power.


-a


On 28 September 2016 at 20:51, Mori Hiroki <yamori813 at yahoo.co.jp> wrote:
> Hi.
>
> on WZR-HP-G300NH(AR9132) OK
>
>
>
> # usbconfig
> ugen0.1: <EHCI root HUB Atheros> at usbus0, cfg=0 md=HOST spd=HIGH (480Mbps) pwr
> =SAVE (0mA)
> ugen0.2: <USB IR REMOCON Bit Trade One LTD.> at usbus0, cfg=0 md=HOST spd=FULL (
> 12Mbps) pwr=ON (100mA)
> #
>
>
> on WZR-HP-AG300H(AR7161) NG
>
> # usbconfig
> ugen0.1: <OHCI root HUB Atheros> at usbus0, cfg=0 md=HOST spd=FULL (12Mbps) pwr=
> SAVE (0mA)
> ugen1.1: <EHCI root HUB Atheros> at usbus1, cfg=0 md=HOST spd=HIGH (480Mbps) pwr
> =SAVE (0mA)
>
> I use ZRouter on build. I check hints file. I seem same as
> sys/mips/conf/AP96.hints.
>
> Thanks
>
> Hiroki Mori
>
>
>
> ----- Original Message -----
>> From: Sean Bruno <sbruno at freebsd.org>
>> To: freebsd-mips at freebsd.org
>> Cc:
>> Date: 2016/9/27, Tue 23:10
>> Subject: Re: AR7161 USB
>>
>>
>>
>> On 09/27/16 04:02, Mori Hiroki wrote:
>>>  Hi.
>>>
>>>  I try to use AR7161 target(WZR-HP-AG300H) on head today.
>>>  But I can't use USB this target. Device is probe on boot but USB device
>>>  insert not detect device.
>>>
>>>  Any one use this ?
>>>
>>>  Regards.
>>>
>>>  Hiroki Mori
>>
>> Is umass.ko loaded? (I assume you are using a USB storage device).
>>
>> sean
>>
> _______________________________________________
> freebsd-mips at freebsd.org mailing list
> https://lists.freebsd.org/mailman/listinfo/freebsd-mips
> To unsubscribe, send any mail to "freebsd-mips-unsubscribe at freebsd.org"