Install problem HP integrity rx2660(Montecito)
Richard Walter
Richard.Walter at hob.de
Thu May 10 13:40:51 UTC 2007
Hello,
i've waited about half an hour, nothing happened. I then tried to boot with the
uniprocessor kernel and verbose mode with
"set kern.smp.disabled=1" and "boot -v"
Threading is not activated within the EFI cpuinfo.
Regards,
Richard
Here is the output:
Hit [Enter] to boot immediately, or any other key for command prompt.
Booting [/boot/kernel/kernel] in 8 seconds...
Type '?' for a list of commands, 'help' for more detailed help.
OK set kern.smp.disabled=1
OK boot -v
Entering /boot/kernel/kernel at 0xe000000004068000...
PAL Proc at 0xe00000003f800010
SAL Proc at 0xe00000003ff9eae0, GP at 0xe00000003fe00000
SAL: AP wake-up vector: 0xff
Platform clock frequency 266117891 Hz
Processor ratio 1600/267, Bus ratio 1/1, ITC ratio 6/4
Skipping memory chunk start 0x100000000
Skipping memory chunk start 0x10040000000
Skipping memory chunk start 0x100ff000000
Skipping memory chunk start 0x100ff801000
Skipping memory chunk start 0x100ffa00000
Skipping memory chunk start 0x100ffe00000
Skipping memory chunk start 0x100ffe80000
ptc.e base=0x0, count1=1, count2=1, stride1=0x0, stride2=0x0
Processor supports 24 Region ID bits
Trying VHPT size 0x400000
Putting VHPT at 0x400000
Splitting [0x102000-0x4000000]
GDB: debug ports: uart
GDB: current port: uart
KDB: debugger backends: ddb gdb
KDB: current backend: ddb
Copyright (c) 1992-2007 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 7.0-CURRENT-200704 #0: Sat Apr 14 03:19:00 UTC 2007
root at pluto1.freebsd.org:/usr/obj/usr/src/sys/GENERIC
Using 32 colors for the VM-PQ tuning (0, 0)
UNWIND: table added: base=e000000004000000, start=e0000000049c73e8, end=e0000000049ff728
Preloaded elf kernel "/boot/kernel/kernel" at 0xe0000000053cc940.
Preloaded mfs_root "/boot/mfsroot" at 0xe0000000053cca20.
CPU: Montecito (1594.71-Mhz Itanium 2)
Origin = "GenuineIntel" Revision = 7
Features = 0x5<LB,AO>
real memory = 1050492928 (1001 MB)
Physical memory chunk(s):
0x01c00000 - 0x03ffffff, 37748736 bytes (4608 pages)
0x053ce000 - 0x3d971fff, 945438720 bytes (115410 pages)
0x3fc00000 - 0x3fdd5fff, 1925120 bytes (235 pages)
avail memory = 978149376 (932 MB)
FPSWA Revision = 0x10012, Entry = 0xe0000100ffd18050
Table 'FACP' at 0xe00000003fdf6af8
Table 'SPCR' at 0xe00000003fdf6c30
Table 'DBGP' at 0xe00000003fdf6c80
Table 'APIC' at 0xe00000003fdf70a0
Local APIC address=0xfee00000
Local APIC override entry
Local APIC address=0xfee00000
Local SAPIC entry
ProcessorId=0x0, Id=0x0, Eid=0x0
Local SAPIC entry
ProcessorId=0x1, Id=0x1, Eid=0x0 (disabled)
Local SAPIC entry
ProcessorId=0x2, Id=0x2, Eid=0x0
Local SAPIC entry
ProcessorId=0x3, Id=0x3, Eid=0x0 (disabled)
Local SAPIC entry
ProcessorId=0x4, Id=0x4, Eid=0x0
Local SAPIC entry
ProcessorId=0x5, Id=0x5, Eid=0x0 (disabled)
Local SAPIC entry
ProcessorId=0x6, Id=0x6, Eid=0x0
Local SAPIC entry
ProcessorId=0x7, Id=0x7, Eid=0x0 (disabled)
I/O SAPIC entry
Id=0x0, InterruptBase=0x10, Address=0xfed20800
I/O SAPIC entry
Id=0x2, InterruptBase=0x1b, Address=0xfed24800
I/O SAPIC entry
Id=0x3, InterruptBase=0x26, Address=0xfed26800
I/O SAPIC entry
Id=0x6, InterruptBase=0x31, Address=0xfed2c800
I/O SAPIC entry
Id=0x7, InterruptBase=0x3c, Address=0xfed2e800
Table 'SPMI' at 0xe00000003fdf6cb8
Table 'CPEP' at 0xe00000003fdf6f70
Table 'SSDT' at 0xe00000003fdf3fc8
Table 'SSDT' at 0xe00000003fdf4488
Table 'SSDT' at 0xe00000003fdf48e8
Table 'SSDT' at 0xe00000003fdf5158
Table 'SSDT' at 0xe00000003fdf59c8
Table 'SSDT' at 0xe00000003fdf6238
Table 'SSDT' at 0xe00000003fdf6378
Table 'SSDT' at 0xe00000003fdf6468
Table 'SSDT' at 0xe00000003fdf65a8
Table 'SSDT' at 0xe00000003fdf6698
Table 'SSDT' at 0xe00000003fdf67d8
Table 'SSDT' at 0xe00000003fdf68c8
Table 'SSDT' at 0xe00000003fdf6a08
Table 'WDAT' at 0xe00000003fdf6da8
MCA: allocated 65536 bytes for state info.
mem: <memory>
null: <null device, zero device>
nfslock: pseudo-device
random: <entropy source, Software, Yarrow>
ACPI: RSDP @ 0x0x3fde6000/0x0028 (v 2 HP)
ACPI: XSDT @ 0x0x3fde602c/0x00C4 (v 1 HP rx2660 0x00000000 HP 0x00000000)
ACPI: FACP @ 0x0x3fdf6af8/0x00F4 (v 3 HP rx2660 0x00000000 HP 0x00000000)
ACPI: DSDT @ 0x0x3fde61c8/0xDDF1 (v 1 HP rx2660 0x00000007 INTL 0x20050309)
ACPI: FACS @ 0x0x3fdf6bf0/0x0040
ACPI: SPCR @ 0x0x3fdf6c30/0x0050 (v 1 HP 0x00000000 HP 0x00000000)
ACPI: DBGP @ 0x0x3fdf6c80/0x0034 (v 1 HP rx2660 0x00000000 HP 0x00000000)
ACPI: APIC @ 0x0x3fdf70a0/0x00E8 (v 1 HP rx2660 0x00000000 HP 0x00000000)
ACPI: SPMI @ 0x0x3fdf6cb8/0x0050 (v 4 HP rx2660 0x00000000 HP 0x00000000)
ACPI: CPEP @ 0x0x3fdf6f70/0x0034 (v 1 HP rx2660 0x00000000 HP 0x00000000)
ACPI: SSDT @ 0x0x3fdf3fc8/0x04B3 (v 1 HP rx2660 0x00000006 INTL 0x20050309)
ACPI: SSDT @ 0x0x3fdf4488/0x0457 (v 1 HP rx2660 0x00000006 INTL 0x20050309)
ACPI: SSDT @ 0x0x3fdf48e8/0x0866 (v 1 HP rx2660 0x00000006 INTL 0x20050309)
ACPI: SSDT @ 0x0x3fdf5158/0x0866 (v 1 HP rx2660 0x00000006 INTL 0x20050309)
ACPI: SSDT @ 0x0x3fdf59c8/0x0866 (v 1 HP rx2660 0x00000006 INTL 0x20050309)
ACPI: SSDT @ 0x0x3fdf6238/0x0138 (v 1 HP rx2660 0x00000006 INTL 0x20050309)
ACPI: SSDT @ 0x0x3fdf6378/0x00E0 (v 1 HP rx2660 0x00000006 INTL 0x20050309)
ACPI: SSDT @ 0x0x3fdf6468/0x013C (v 1 HP rx2660 0x00000006 INTL 0x20050309)
ACPI: SSDT @ 0x0x3fdf65a8/0x00E0 (v 1 HP rx2660 0x00000006 INTL 0x20050309)
ACPI: SSDT @ 0x0x3fdf6698/0x013C (v 1 HP rx2660 0x00000006 INTL 0x20050309)
ACPI: SSDT @ 0x0x3fdf67d8/0x00E0 (v 1 HP rx2660 0x00000006 INTL 0x20050309)
ACPI: SSDT @ 0x0x3fdf68c8/0x013C (v 1 HP rx2660 0x00000006 INTL 0x20050309)
ACPI: SSDT @ 0x0x3fdf6a08/0x00E0 (v 1 HP rx2660 0x00000006 INTL 0x20050309)
ACPI: WDAT @ 0x0x3fdf6da8/0x01C4 (v 1 HP rx2660 0x00000000 HP 0x00000000)
acpi0: <HP> on motherboard
>
> o Montecito is a dual-core processor. I think it also has
> hyperthreads. This may be the discrepancy between the
> detection of 4 cpus and only having woken 2 (cpu 0 and 2).
> Unfortunately, I don't have a montecito-based machine,
> so there's no support for montecito. Try building an UP
> kernel and see if it boots.
> o Normally it takes a while after "acpi0: <HP> on motherboard"
> before there's more output. I don't know how long you waited
> but make sure it's at least 10 minutes to begin with (just
> to be sure).
> o Try booting verbose. It may tell a bit more.
>
> HTH,
>
____________
Virus checked by G DATA AntiVirusKit
Version: AVK 17.4565 from 10.05.2007
Virus news: www.antiviruslab.com
More information about the freebsd-ia64
mailing list