porting a webcam
Bernd Walter
ticso at cicely12.cicely.de
Fri Aug 8 09:06:20 PDT 2003
On Fri, Aug 08, 2003 at 07:56:26AM -0700, Paulo Roberto wrote:
> Hello,
>
> I am about to code my first kmod. I am trying to port an usb camera to
> FreeBSD, and since I am new at system development, I hope you don't
> mind helping me out. If this is not the correct list I should post,
> please point me what list I should post to.
>
> I got a few questions:
>
> * Does the 5 series differs too much to from the 4-stable to write a
> device driver? I am planning to code for 4.8 (the one I am using now)
> and I wonder how hard would it be to port it later to the 5 series.
>
> * I am reading the developers handbook, is there another good reference
> recommended? Any good point of reference for usb/camera
> protocols/device drivers?
>
> * You guys think it is too difficult and I should just give up due to
> my lack of experience? And if I manage to code properly, is it too
> bureaucratic to get it into the FreeBSD kernel?
I wouldn't write a kernel driver for a camera and use ugen(4) instead.
The state of ugen is similar in 4.x and 5.x so you don't have to worry
about a special version.
The most important part is getting informations about the protocol
used by your camera.
--
B.Walter BWCT http://www.bwct.de
ticso at bwct.de info at bwct.de
More information about the freebsd-hackers
mailing list