Updated switch/glue patch?

[Adrian Chadd]

I think I was a bit too quick. It turns out that after a few minutes
of uptime, I get the same behaviour from your iicbb changes.

# etherswitchcfg
port0:
        vlangroup: 1
        media: Ethernet autoselect (none)
        status: no carrier
port1:
        vlangroup: 0
        media: Ethernet autoselect (1000baseT <full-duplex>)
        status: active
port2:
        vlangroup: 0
        media: Ethernet autoselect (none)
        status: no carrier
port3:
        vlangroup: 0
        media: Ethernet autoselect (none)
        status: no carrier
port4:
        vlangroup: 0
        media: Ethernet autoselect (none)
        status: no carrier
port5:
        vlangroup: 0
        media: Ethernet 1000baseT <full-duplex>
        status: active
vlangroup0:
        vlan: 1
        members 1,2,3,4,5
vlangroup1:
        vlan: 2
        members 0,5t

.. then after a few minutes:

# rtl8366rb0port1: link state changed to DOWN

#
#
# etherswitchcfg

port0:
        vlangroup: 0
        media: Ethernet autoselect
        status: no carrier
port1:
        vlangroup: 0
        media: Ethernet autoselect
        status: no carrier
port2:
        vlangroup: 0
        media: Ethernet autoselect
        status: no carrier
port3:
        vlangroup: 0
        media: Ethernet autoselect
        status: no carrier
port4:
        vlangroup: 0
        media: Ethernet autoselect
        status: no carrier
port5:
        vlangroup: 0
        media: Ethernet 10baseT/UTP
        status: active

.. I wonder what's going on there.



Adrian