ulpt can't attach Lexmark E120
George Mitchell
george+freebsd at m5p.com
Fri Aug 30 00:38:59 UTC 2013
On 08/25/13 04:44, Hans Petter Selasky wrote:
> On 08/24/13 20:21, George Mitchell wrote:
>>
>> Setting hw.usb.dwc_otg.debug to any value greater than 0 generates an
>> unending stream of debug output and effectively locks up the chip
>> scrolling the output on the display. Perhaps there are some specific
>> debug messages I could put in ... -- George
>
> Hi,
>
> Can you try this patch:
>
> http://svnweb.freebsd.org/changeset/base/254828
>
> --HPS
> _______________________________________________
> freebsd-current at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-current
> To unsubscribe, send any mail to "freebsd-current-unsubscribe at freebsd.org"
Finally my RPi build system is working again and I can happily report
that my Lexmark printer attaches successfully! Thank you! (And I
note the patch has been checked into the repository.) -- George
More information about the freebsd-current
mailing list