[Soekris] FreeBSD 9.0 beta on a Net5501?

Mike Tancsa mike at sentex.net
Sun Aug 14 23:27:44 UTC 2011

On 8/14/2011 3:50 PM, C. P. Ghost wrote:
> On Thu, Aug 4, 2011 at 2:21 PM, Patrick Lamaiziere
> <patfbsd at davenulle.org> wrote:
>> Hello,
>> I've tried to update my net5501 running an old FreeBSD-current from
>> october to 9.0 beta 1. Unfortunaly installworld crashed and the system
>> is broken now :
>> Instruction interdite(core dumped)
>> (instruction interdite => illegal/forbidden instruction)
>> The world and kernel were built with llvm/clang.
> [CC-ing freebsd-current@]
> Is this issue resolved?
> I'm having a bunch of net4801 in production here,
> and I was planning to move them to 9.0 soon after
> RELEASE. So thanks for the heads up. I'll be holding
> back now, and will stay with 8.2-STABLE.
> Unfortunately, I have no spare net4801 (and no net5501)
> at the moment, so I can't test BETA on them. :(
>> Could you tell me if it works for you on a net5501?

Not sure about the 4801, I dont have one online right now. But I
netbooted a 5501 and it seems fine. KERNEL is essentially GENERIC minus
the debug stuff

+option          CPU_GEODE
+option          CPU_SOEKRIS
+ident          ipsec

BTW, watchdog seems to work fine as I just tested that

soekris3# cat /var/run/dmesg.boot
Copyright (c) 1992-2011 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 9.0-BETA1 #2: Sun Aug 14 19:15:05 EDT 2011
    mdtancsa at ich10.sentex.ca:/usr/HEAD/obj/usr/HEAD/src/sys/ipsec i386
ACPI Error: A valid RSDP was not found (20110527/tbxfroot-237)
module_register: module pci/xhci already exists!
Module pci/xhci failed to register: 17
CPU: Geode(TM) Integrated Processor by AMD PCS (433.26-MHz 586-class CPU)
  Origin = "AuthenticAMD"  Id = 0x5a2  Family = 5  Model = a  Stepping = 2
  AMD Features=0xc0400000<MMX+,3DNow!+,3DNow!>
real memory  = 268435456 (256 MB)
avail memory = 247726080 (236 MB)
K6-family MTRR support enabled (2 registers)
kbd1 at kbdmux0
ACPI Error: A valid RSDP was not found (20110527/tbxfroot-237)
ACPI: Table initialisation failed: AE_NOT_FOUND
ACPI: Try disabling either ACPI or apic support.
cryptosoft0: <software crypto> on motherboard
pcib0: <Host to PCI bridge> pcibus 0 on motherboard
pci0: <PCI bus> on pcib0
Geode LX: Soekris net5501 comBIOS ver. 1.33 20070103 Copyright (C) 2000-2007
pci0: <encrypt/decrypt, entertainment crypto> at device 1.2 (no driver
vr0: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe100-0xe1ff mem
0xa0004000-0xa00040ff irq 11 at device 6.0 on pci0
vr0: Quirks: 0x2
vr0: Revision: 0x96
miibus0: <MII bus> on vr0
ukphy0: <Generic IEEE 802.3u media interface> PHY 1 on miibus0
ukphy0:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
vr0: Ethernet address: 00:00:24:c9:aa:9c
vr1: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe200-0xe2ff mem
0xa0004100-0xa00041ff irq 5 at device 7.0 on pci0
vr1: Quirks: 0x2
vr1: Revision: 0x96
miibus1: <MII bus> on vr1
ukphy1: <Generic IEEE 802.3u media interface> PHY 1 on miibus1
ukphy1:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
vr1: Ethernet address: 00:00:24:c9:aa:9d
vr2: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe300-0xe3ff mem
0xa0004200-0xa00042ff irq 9 at device 8.0 on pci0
vr2: Quirks: 0x2
vr2: Revision: 0x96
miibus2: <MII bus> on vr2
ukphy2: <Generic IEEE 802.3u media interface> PHY 1 on miibus2
ukphy2:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
vr2: Ethernet address: 00:00:24:c9:aa:9e
vr3: <VIA VT6105M Rhine III 10/100BaseTX> port 0xe400-0xe4ff mem
0xa0004300-0xa00043ff irq 12 at device 9.0 on pci0
vr3: Quirks: 0x2
vr3: Revision: 0x96
miibus3: <MII bus> on vr3
ukphy3: <Generic IEEE 802.3u media interface> PHY 1 on miibus3
ukphy3:  none, 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
vr3: Ethernet address: 00:00:24:c9:aa:9f
isab0: <PCI-ISA bridge> at device 20.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <AMD CS5536 UDMA100 controller> port
0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0xe000-0xe00f at device 20.2 on pci0
ata0: <ATA channel 0> on atapci0
ata1: <ATA channel 1> on atapci0
ohci0: <OHCI (generic) USB controller> mem 0xa0005000-0xa0005fff irq 15
at device 21.0 on pci0
usbus0: <OHCI (generic) USB controller> on ohci0
ehci0: <AMD CS5536 (Geode) USB 2.0 controller> mem 0xa0006000-0xa0006fff
irq 15 at device 21.1 on pci0
usbus1: EHCI version 1.0
usbus1: <AMD CS5536 (Geode) USB 2.0 controller> on ehci0
cpu0 on motherboard
pmtimer0 on isa0
orm0: <ISA Option ROM> at iomem 0xc8000-0xd27ff pnpid ORM0000 on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
kbd0 at atkbd0
atkbd0: [GIANT-LOCKED]
atrtc0: <AT realtime clock> at port 0x70 irq 8 on isa0
Event timer "RTC" frequency 32768 Hz quality 0
ppc0: parallel port not found.
uart0: <16550 or compatible> at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
uart0: console (115200,n,8,1)
uart1: <16550 or compatible> at port 0x2f8-0x2ff irq 3 on isa0
Timecounters tick every 0.976 msec
usbus0: 12Mbps Full Speed USB v1.0
usbus1: 480Mbps High Speed USB v2.0
ugen0.1: <AMD> at usbus0
uhub0: <AMD OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus0
ugen1.1: <AMD> at usbus1
uhub1: <AMD EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> on usbus1
Timecounter "TSC" frequency 433257343 Hz quality 800
Root mount waiting for: usbus1 usbus0
uhub0: 4 ports with 4 removable, self powered
Root mount waiting for: usbus1
uhub1: 4 ports with 4 removable, self powered
Trying to mount root from nfs: []...
stray irq7

Mike Tancsa, tel +1 519 651 3400
Sentex Communications, mike at sentex.net
Providing Internet services since 1994 www.sentex.net
Cambridge, Ontario Canada   http://www.tancsa.com/

More information about the freebsd-current mailing list