Testing CAM wrapper for ata(4) controller drivers
Alexander Motin
mav at FreeBSD.org
Mon Dec 14 04:13:04 PST 2009
Tom Uffner wrote:
> this change breaks my Promise SATA card
Are you sure that it was this change?
> atapci0: <Promise PDC20771 SATA300 controller> port
> 0xdc00-0xdc7f,0xd800-0xd8ff mem
> 0xfeaff000-0xfeafffff,0xfeac0000-0xfeadffff irq 23 at device 11.0 on pci2
>
> kernels from after the commit on 12/6 are unable to mount my drives.
> i get (from memory, since i can't even get to single user mode)
> WARNING - READ_DMA UDMA ICRC error
> followed by lots of SETFEATURE foo errors then a READ_DMA timeout
> followed by a bus reset and the cycle repeats...
>
> before this commit it worked fine.
How long ago?
> this is in the legacy mode. i am building a kernel with "options ATA_CAM"
> now
OK. Tell me if there any difference.
Send me please full _verbose_ dmesg with original kernel and if possible
with new. If you can't get full with new, enable verbose messages and
make screenshots of drives detection and first errors.
--
Alexander Motin
More information about the freebsd-current
mailing list