boot hang with 7.1BETA2 (12/08) an no wifi

Neal Hogan nealhogan at gmail.com
Mon Dec 8 21:50:23 UTC 2008


Hi,

I'm new to fBSD and recently installed 7.0 on my HP pavillion ze4400
(multiboot w/ XP). It appeared to work fine. I had it on there for several
weeks and was just snooping around. Well, I attempted to upgrade to 7.1
prerelease. I used *freebsd-update upgrade -r 7.1-BETA2*  and it seemed to
work. However, when I reboot the system is hung after the the following
line: pci1: <ACPI PCI bus> on pcib1. I reboot with ACPI disabled and it boot
fine. Below is my dmesg.

Also, my wifi card doesn't work and I don't see it in the dmesg. The same
was true of 7.0. This computer is older than my interest in *BSD. So, I
don't know what card it has. Note that it works under XP. Thanks.

Copyright (c) 1992-2008 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
	The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 7.1-PRERELEASE-p1 #0: Mon Nov 24 11:49:24 UTC 2008
    root at i386-builder.daemonology.net:/usr/obj/usr/src/sys/GENERIC
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: mobile AMD Athlon(tm) XP2400+ (1788.94-MHz 686-class CPU)
  Origin = "AuthenticAMD"  Id = 0x6a0  Stepping = 0
  Features=0x383f9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
  AMD Features=0xc0480800<SYSCALL,MP,MMX+,3DNow!+,3DNow!>
real memory  = 468647936 (446 MB)
avail memory = 444547072 (423 MB)
kbd1 at kbdmux0
ath_hal: 0.9.20.3 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413)
pcib0: <Host to PCI bridge> pcibus 0 on motherboard
pir0: <PCI Interrupt Routing Table: 11 Entries> on motherboard
$PIR: Using invalid BIOS IRQ 5 from 0.10.INTA for link 0x6
pci0: <PCI bus> on pcib0
agp0: <ATI RS100 AGP bridge> on hostb0
pcib1: <PCIBIOS PCI-PCI bridge> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
vgapci0: <VGA-compatible display> port 0x9000-0x90ff mem
0xe0000000-0xefffffff,0xd0100000-0xd010ffff irq 10 at device 5.0 on
pci1
ohci0: <AcerLabs M5237 (Aladdin-V) USB controller> mem
0xd0006000-0xd0006fff irq 9 at device 2.0 on pci0
ohci0: [GIANT-LOCKED]
ohci0: [ITHREAD]
usb0: OHCI version 1.0, legacy support
usb0: SMM does not respond, resetting
usb0: <AcerLabs M5237 (Aladdin-V) USB controller> on ohci0
usb0: USB revision 1.0
uhub0: <AcerLabs OHCI root hub, class 9/0, rev 1.00/1.00, addr 1> on usb0
uhub0: 4 ports with 4 removable, self powered
pcm0: <Acer Labs M5451> port 0x8400-0x84ff mem 0xd0007000-0xd0007fff
irq 5 at device 6.0 on pci0
pcm0: <Conexant CX20468 AC97 Codec>
pcm0: [GIANT-LOCKED]
pcm0: [ITHREAD]
isab0: <PCI-ISA bridge> at device 7.0 on pci0
isa0: <ISA bus> on isab0
pci0: <simple comms, generic modem> at device 8.0 (no driver attached)
pci0: <network> at device 9.0 (no driver attached)
cbb0: <O2Micro OZ6912/6972 PCI-CardBus Bridge> mem
0x80000000-0x80000fff irq 5 at device 10.0 on pci0
cardbus0: <CardBus bus> on cbb0
pccard0: <16-bit PCCard bus> on cbb0
cbb0: [ITHREAD]
fwohci0: <Texas Instruments TSB43AB21/A/AI/A-EP> mem
0xd0009000-0xd00097ff,0xd0000000-0xd0003fff irq 10 at device 12.0 on
pci0
fwohci0: [FILTER]
fwohci0: OHCI version 1.10 (ROM=1)
fwohci0: No. of Isochronous channels is 4.
fwohci0: EUI64 00:0d:9d:71:9e:43:0c:6a
fwohci0: Phy 1394a available S400, 1 ports.
fwohci0: Link S400, max_rec 2048 bytes.
firewire0: <IEEE1394(FireWire) bus> on fwohci0
fwe0: <Ethernet over FireWire> on firewire0
if_fwe0: Fake Ethernet address: 02:0d:9d:43:0c:6a
fwe0: Ethernet address: 02:0d:9d:43:0c:6a
fwip0: <IP over FireWire> on firewire0
fwip0: Firewire address: 00:0d:9d:71:9e:43:0c:6a @ 0xfffe00000000,
S400, maxrec 2048
sbp0: <SBP-2/SCSI over FireWire> on firewire0
dcons_crom0: <dcons configuration ROM> on firewire0
dcons_crom0: bus_addr 0x12c0000
fwohci0: Initiate bus reset
fwohci0: BUS reset
fwohci0: node_id=0xc000ffc0, gen=1, CYCLEMASTER mode
atapci0: <AcerLabs M5229 UDMA100 controller> port
0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0x8080-0x808f at device 16.0 on
pci0
atapci0: using PIO transfers above 137GB as workaround for 48bit DMA
access bug, expect reduced performance
ata0: <ATA channel 0> on atapci0
ata0: [ITHREAD]
ata1: <ATA channel 1> on atapci0
ata1: [ITHREAD]
pci0: <bridge> at device 17.0 (no driver attached)
sis0: <NatSemi DP8381[56] 10/100BaseTX> port 0x8c00-0x8cff mem
0xd000a000-0xd000afff irq 11 at device 18.0 on pci0
sis0: Silicon Revision: DP83816A
miibus0: <MII bus> on sis0
nsphyter0: <DP83815 10/100 media interface> PHY 0 on miibus0
nsphyter0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
sis0: Ethernet address: 00:0d:9d:43:2b:a7
sis0: [ITHREAD]
cpu0 on motherboard
powernow0: <PowerNow! K7> on cpu0
pmtimer0 on isa0
orm0: <ISA Option ROMs> at iomem
0xc0000-0xcefff,0xcf000-0xcf7ff,0xdb000-0xdbfff,0xdc000-0xdffff pnpid
ORM0000 on isa0
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
kbd0 at atkbd0
atkbd0: [GIANT-LOCKED]
atkbd0: [ITHREAD]
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: [GIANT-LOCKED]
psm0: [ITHREAD]
psm0: model IntelliMouse, device ID 3
fdc0: <Enhanced floppy controller> at port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on isa0
fdc0: [FILTER]
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/16 bytes threshold
ppbus0: <Parallel port bus> on ppc0
ppbus0: [ITHREAD]
plip0: <PLIP network interface> on ppbus0
plip0: WARNING: using obsoleted IFF_NEEDSGIANT flag
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
ppi0: <Parallel I/O> on ppbus0
ppc0: [GIANT-LOCKED]
ppc0: [ITHREAD]
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A
sio0: [FILTER]
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
unknown: <PNP0c02> can't assign resources (memory)
unknown: <PNP0c01> can't assign resources (memory)
unknown: <PNP0303> can't assign resources (port)
unknown: <PNP0c02> can't assign resources (memory)
unknown: <PNP0c02> can't assign resources (memory)
unknown: <PNP0501> can't assign resources (port)
unknown: <PNP0f13> can't assign resources (irq)
unknown: <PNP0700> can't assign resources (port)
unknown: <PNP0401> can't assign resources (port)
ums0: <Logitech USB Receiver, class 0/0, rev 1.10/25.00, addr 2> on uhub0
ums0: 16 buttons and Z dir.
umass0: <Memorex TD CLASSIC 003B, class 0/0, rev 2.00/1.00, addr 3> on uhub0
Timecounter "TSC" frequency 1788940177 Hz quality 800
Timecounters tick every 1.000 msec
firewire0: 1 nodes, maxhop <= 0, cable IRM = 0 (me)
firewire0: bus manager 0 (me)
ad0: 95396MB <Seagate ST9100823A 3.02> at ata0-master UDMA100
acd0: CDRW <QSI CD-RW/DVD-ROM SBW-241/VH04> at ata1-master UDMA33
da0 at umass-sim0 bus 0 target 0 lun 0
da0: <Memorex TD CLASSIC 003B PMAP> Removable Direct Access SCSI-0 device
da0: 1.000MB/s transfers
da0: 246MB (503808 512 byte sectors: 64H 32S/T 246C)
Trying to mount root from ufs:/dev/ad0s2a
WARNING: / was not properly dismounted
WARNING: /usr was not properly dismounted
/usr: mount pending error: blocks 56 files 2
WARNING: /var was not properly dismounted


-- 
www.nealhogan.net


More information about the freebsd-current mailing list