vge(4) driver not working at 1G speeds

[Stuart Fraser]

Oops, no coffee yet, here you go.

pcib3: slot 0 INTA hardwired to IRQ 28
vge0: <VIA Networking Gigabit Ethernet> port 0xe800-0xe8ff mem
0xfeaffc00-0xfeaffcff irq 28 at device 0.0 on pci3
vge0: Reserved 0x100 bytes for rid 0x14 type 3 at 0xfeaffc00
miibus0: <MII bus> on vge0
ukphy0: <Generic IEEE 802.3u media interface> PHY 22 on miibus0
ukphy0: OUI 0x0090c3, model 0x0019, rev. 0
ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
1000baseT-FDX, auto
vge0: using obsoleted if_watchdog interface
vge0: bpf attached
vge0: Ethernet address: 00:40:63:f3:7e:28
ioapic1: routing intpin 4 (PCI IRQ 28) to vector 49
vge0: [MPSAFE]
vge0: [ITHREAD]


ta
S

-----Original Message-----
From: owner-freebsd-current at freebsd.org
[mailto:owner-freebsd-current at freebsd.org] On Behalf Of Pyun YongHyeon
Sent: 02 April 2008 09:17
To: Stuart Fraser
Cc: freebsd-current at freebsd.org
Subject: Re: vge(4) driver not working at 1G speeds

On Wed, Apr 02, 2008 at 08:29:27AM +0100, Stuart Fraser wrote:
 > Hi,
 > Here is the dmesg section, it appears to be using UKPHY so as you say if
the
 > older chips used a different physical layer perhaps we have a problem in
 > there.
 > 
 > -- dmesg --
 > pci3: <ACPI PCI bus> on pcib3
 > vge0: <VIA Networking Gigabit Ethernet> port 0xe800-0xe8ff mem
 > 0xfeaffc00-0xfeaffcff irq 28 at device 0.0 on pci3
 > miibus0: <MII bus> on vge0
 > ukphy0: <Generic IEEE 802.3u media interface> PHY 22 on miibus0

This is the reason why I requested verbosed boot messages.
ukphy(4) prints OUI/model number of the PHY in verbosed boot mode.
Would you show me that information?

 > ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
 > 1000baseT-FDX, auto
 > vge0: using obsoleted if_watchdog interface
 > vge0: Ethernet address: 00:40:63:f3:7e:28
 > vge0: [ITHREAD]
 > 

-- 
Regards,
Pyun YongHyeon
_______________________________________________
freebsd-current at freebsd.org mailing list
http://lists.freebsd.org/mailman/listinfo/freebsd-current
To unsubscribe, send any mail to "freebsd-current-unsubscribe at freebsd.org"