Only 100baseTX with bge BCM5722

[David Christensen]

> >
> > What's the dmesg output?  Is it using ukphy or brgphy?
> >
>
> Partial dmesg, concerning the NIC:
>
> pcib4: <ACPI PCI-PCI bridge> irq 17 at device 28.5 on pci0
> pci14: <ACPI PCI bus> on pcib4
> bge0: <HP NC105i PCIe Gigabit Server Adapter, ASIC rev. 0xa200> mem
> 0xed000000-0xed00ffff irq 17 at device 0.0 on pci14
> miibus0: <MII bus> on bge0
> ukphy0: <Generic IEEE 802.3u media interface> PHY 1 on miibus0
> ukphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
> 1000baseT-FDX, auto
> bge0: Ethernet address: XXXXXXXXXXXXXXXXXXXXX
> bge0: [ITHREAD]
>
> bge0: link state changed to UP
>
> Must I try 1000baseT-FDX instead than 1000baseTX in my ifconfig line?

The 5722 PHY ID is available in -HEAD (see
http://fxr.watson.org/fxr/source/dev/mii/miidevs#L139)
but isn't present in RELENG_7_0 (see
http://fxr.watson.org/fxr/source/dev/mii/miidevs?v=RELENG70#L115).

Look at the diffs between sys/dev/mii/miidevs and sys/dev/mii/brgphy
between HEAD and RELENG_7_0 and pull in the changes for the 5722 and
build them into your kernel.  If successful you should see brgphy0
and not ukphy0.

Dave