HP Proliant system freezes when bge NIC is used

[Anders Nordby]

Hi,

Using FreeBSD/amd64 7.0-BETA1 on a HP Proliant DL 380 G4 system, it freezes
totally once the NIC is used, hanging at the time of setting the
hostname upon boot. If I set hw.bge.allow_asf="0" in loader.conf, it
works fine. What can I do to help debug this problem?

About my NICs:

bge0: <HP NC7782 Gigabit Server Adapter, ASIC rev. 0x2100> mem
0xfdef0000-0xfdef
ffff irq 25 at device 1.0 on pci3    
bge0: Reserved 0x10000 bytes for rid 0x10 type 3 at 0xfdef0000
miibus0: <MII bus> on bge0
brgphy0: <BCM5704 10/100/1000baseTX PHY> PHY 1 on miibus0
brgphy0: OUI 0x000818, model 0x0019, rev. 0
brgphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
1000baseT-F
DX, auto
bge0: bpf attached
bge0: Ethernet address: 00:12:79:cf:57:33    
ioapic1: routing intpin 1 (PCI IRQ 25) to vector 49
bge0: [MPSAFE]  
bge0: [ITHREAD]
pci0:3:1:1: bad VPD cksum, remain 19       
bge1: <HP NC7782 Gigabit Server Adapter, ASIC rev. 0x2100> mem
0xfdee0000-0xfdee
ffff irq 26 at device 1.1 on pci3
bge1: Reserved 0x10000 bytes for rid 0x10 type 3 at 0xfdee0000
miibus1: <MII bus> on bge1
brgphy1: <BCM5704 10/100/1000baseTX PHY> PHY 1 on miibus1
brgphy1: OUI 0x000818, model 0x0019, rev. 0
brgphy1:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT,
1000baseT-F
DX, auto
bge1: bpf attached
bge1: Ethernet address: 00:12:79:cf:57:32
ioapic1: routing intpin 2 (PCI IRQ 26) to vector 50
bge1: [MPSAFE]
bge1: [ITHREAD]

Only bge0 is being used. This seems to be the same problem described in
PR kern/116328.

Any takers?

Bye,

-- 
Anders.