bge auto-negotiation fails with recent current
Pyun YongHyeon
pyunyh at gmail.com
Sat Jun 9 02:18:36 UTC 2007
On Fri, Jun 08, 2007 at 06:18:04PM +0000, Poul-Henning Kamp wrote:
>
> I have the exact same behaviour with if_re in my "zepto 6615WD"
> laptop.
>
> Dmesg:
> re0: <RealTek 8168/8111B PCIe Gigabit Ethernet> port 0x3000-0x30ff mem 0xcc000000-0xcc000fff irq 16 at device 0.0 on pci2
> miibus0: <MII bus> on re0
> rgephy0: <RTL8169S/8110S media interface> PHY 1 on miibus0
> rgephy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseT, 1000baseT-FDX, auto
> re0: Ethernet address: 00:a0:d1:c1:f9:ad
> re0: [FILTER]
>
Would you let me know model/revision of the PHY?
I guess it uses newer transceiver, RTL8211B(L), from RealTek.
> Poul-Henning
>
> In message <20070608175338.B701745042 at ptavv.es.net>, "Kevin Oberman" writes:
> >--==_Exmh_1181325218_81135P
> >
> >Yesterday I updated my laptop for the first time since May 10. The
> >
> >The bge device does not auto-negotiate.
> >
> >After booting to single-user, but device looks fine
> >media: Ethernet autoselect (100baseTX <full-duplex>)
> >status: active
> >
> >As soon as I do 'ifconfig bge0 up', the link goes down and I see:
> >media: Ethernet autoselect (none)
> >status: no carrier
> >
> >If I manually set the media to 100baseTX, it comes up. If I set it back
> >to autoselect, it again reports "media: Ethernet autoselect (none)" and
> >"Status: no carrier".
>
> --
> Poul-Henning Kamp | UNIX since Zilog Zeus 3.20
> phk at FreeBSD.ORG | TCP/IP since RFC 956
> FreeBSD committer | BSD since 4.3-tahoe
> Never attribute to malice what can adequately be explained by incompetence.
> _______________________________________________
> freebsd-current at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-current
> To unsubscribe, send any mail to "freebsd-current-unsubscribe at freebsd.org"
--
Regards,
Pyun YongHyeon
More information about the freebsd-current
mailing list