boot parameters to disable firewire?

[Joao Barros]

On 6/15/06, David Barbero <sico at loquefaltaba.com> wrote:
> Wojciech A. Koszek escribió:
> > On Thu, Jun 15, 2006 at 02:46:55PM +0200, David Barbero wrote:
> >
> > Could you try to retype a panic message here?
> >
> > Why don't you try disabling FireWire in your BIOS? Could you say which
> > version of FreeBSD are you going to install?
>
> Yes of course:
> Error:
>
> fwohci0: <1394 Open Host Controller Interface> mem
> 0xb4008000-0xb40087ff,0xb4000000-0xb4003fff irq 18 at device 4.2 on pci6
> fwohci0: OHCI version 1.10 (ROM=0)
> fwohci0: No. of Isochronous channels is 4.
> fwohci0: EUI64 XX:XX:XX:XX:XX:XX:XX:XX
> NMI ISA a0, EISA ff
> RAM parity error, likely hardware failure.
>
> Fatal trap 19: non-maskable interrupt trap while in kernel mode
> cpuid = 0; apic id = 00
> instruction pointer     = 0x20:0xc052c256
> stack pointer           = 0x28:0xc10209c4
> frame pointer           = 0x28:0xc10209d8
> code segment            = base 0x0, limit0xfffff, type 0x1b
>                         = DPL 0, pres 1, def32 1, gran 1
> processor eflags        = interrupt enabled, IOPL = 0
> current process         = 0 (swapper)
>
> The BIOS can't support to disable the firewire...
>
> The version is 6.1-RELEASE, but i don't have problem to probe with 7-CURRENT.
>
> In google. the same error show a PR, but i don't find this in PR on
> freebsd web.
>
> http://lists.freebsd.org/pipermail/freebsd-bugs/2006-March/017329.html
>

FYI,

I have a Dell D510 here that boots ok 6.1

-- 
Joao Barros