ndis and Belkin F5D7010 (aka BRoadcom BCM94306)

[Eric Dillenseger]

Hello,

I've been using FreeBSD 5.4 for a while, but switched to -current
to check if acpi support was better for my laptop.
With 5.4, my wireless card was working, but it doesn't anymore on
-current. I have ndis_load="YES" and if_ndis_load="YES" in
/boot/loader.conf, I tried to compile ndis and if_ndis again after
regenerating ndis_driver_data.h with no succes.
When I plug the card, I see Oct  8 20:17:41 coincoin kernel: cardbus0:
<network> at device 0.0 (no driver attached) in messages log.

Here's my dmesg:
(I've fetched the source on Sep 21 12:48)

Copyright (c) 1992-2005 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights
reserved.
FreeBSD 7.0-CURRENT #9: Thu Sep 22 22:47:06 CEST 2005
    root at coincoin.workgroup:/usr/obj/usr/src/sys/GENERIC
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Intel(R) Pentium(R) 4 CPU 2.40GHz (2395.77-MHz 686-class CPU)
  Origin = "GenuineIntel"  Id = 0xf27  Stepping = 7
  Features=0xbfebf9ff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,CLFLUSH,DTS,ACPI,MMX,FXSR,SSE,SSE2,SS,HTT,TM,PBE>
  Features2=0x400<CNTX-ID>
real memory  = 536346624 (511 MB)
avail memory = 515452928 (491 MB)
acpi0: <SONY> on motherboard
acpi_ec0: <Embedded Controller: GPE 0x1c> port 0x62,0x66 on acpi0
pci_link0: <ACPI PCI Link LNKA> irq 9 on acpi0
pci_link1: <ACPI PCI Link LNKB> on acpi0
pci_link2: <ACPI PCI Link LNKC> on acpi0
pci_link3: <ACPI PCI Link LNKD> irq 9 on acpi0
pci_link4: <ACPI PCI Link LNKE> irq 9 on acpi0
pci_link5: <ACPI PCI Link LNKF> on acpi0
pci_link6: <ACPI PCI Link LNKG> on acpi0
pci_link7: <ACPI PCI Link LNKH> on acpi0
Timecounter "ACPI-fast" frequency 3579545 Hz quality 1000
acpi_timer0: <24-bit timer at 3.579545MHz> port 0x1008-0x100b on acpi0
cpu0: <ACPI CPU> on acpi0
acpi_throttle0: <ACPI CPU Throttling> on cpu0
acpi_lid0: <Control Method Lid Switch> on acpi0
acpi_button0: <Power Button> on acpi0
pcib0: <ACPI Host-PCI bridge> port 0xcf8-0xcff on acpi0
pci0: <ACPI PCI bus> on pcib0
agp0: <Intel 82845 host to AGP bridge> mem 0xec000000-0xefffffff at
device 0.0 on pci0
pcib1: <ACPI PCI-PCI bridge> at device 1.0 on pci0
pci1: <ACPI PCI bus> on pcib1
drm0: <ATI Radeon LW RV200 Mobility 7500 M7> port 0x3000-0x30ff mem
0xf0000000-0xf7ffffff,0xe8100000-0xe810ffff irq 9 at device 0.0 on pci1
info: [drm] AGP at 0xec000000 64MB
info: [drm] Initialized radeon 1.16.0 20050311 on minor 0
uhci0: <Intel 82801CA/CAM (ICH3) USB controller USB-A> port
0x1800-0x181f irq 9 at device 29.0 on pci0
uhci0: [GIANT-LOCKED]
usb0: <Intel 82801CA/CAM (ICH3) USB controller USB-A> on uhci0
usb0: USB revision 1.0
uhub0: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
uhci1: <Intel 82801CA/CAM (ICH3) USB controller USB-B> port
0x1820-0x183f irq 9 at device 29.1 on pci0
uhci1: [GIANT-LOCKED]
usb1: <Intel 82801CA/CAM (ICH3) USB controller USB-B> on uhci1
usb1: USB revision 1.0
uhub1: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
uhci2: <Intel 82801CA/CAM (ICH3) USB controller USB-C> port
0x1840-0x185f at device 29.2 on pci0
uhci2: [GIANT-LOCKED]
usb2: <Intel 82801CA/CAM (ICH3) USB controller USB-C> on uhci2
usb2: USB revision 1.0
uhub2: Intel UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub2: 2 ports with 2 removable, self powered
pcib2: <ACPI PCI-PCI bridge> at device 30.0 on pci0
pci2: <ACPI PCI bus> on pcib2
cbb0: <RF5C476 PCI-CardBus Bridge> irq 9 at device 5.0 on pci2
cardbus0: <CardBus bus> on cbb0
pccard0: <16-bit PCCard bus> on cbb0
cbb1: <RF5C476 PCI-CardBus Bridge> at device 5.1 on pci2
cardbus1: <CardBus bus> on cbb1
pccard1: <16-bit PCCard bus> on cbb1
fwohci0: <Ricoh R5C552> mem 0xe8201000-0xe82017ff at device 5.2 on pci2
fwohci0: OHCI version 1.0 (ROM=1)
fwohci0: No. of Isochronous channels is 4.
fwohci0: EUI64 08:00:46:03:01:49:71:0b
fwohci0: Phy 1394a available S400, 2 ports.
fwohci0: Link S400, max_rec 2048 bytes.
firewire0: <IEEE1394(FireWire) bus> on fwohci0
sbp0: <SBP-2/SCSI over FireWire> on firewire0
fwohci0: Initiate bus reset
fwohci0: node_id=0xc800ffc0, gen=1, CYCLEMASTER mode
firewire0: 1 nodes, maxhop <= 0, cable IRM = 0 (me)
firewire0: bus manager 0 (me)
fxp0: <Intel 82801CAM (ICH3) Pro/100 VE Ethernet> port 0x4000-0x403f mem
0xe8200000-0xe8200fff irq 9 at device 8.0 on pci2
miibus0: <MII bus> on fxp0
inphy0: <i82562ET 10/100 media interface> on miibus0
inphy0:  10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
fxp0: Ethernet address: 08:00:46:80:50:11
isab0: <PCI-ISA bridge> at device 31.0 on pci0
isa0: <ISA bus> on isab0
atapci0: <Intel ICH3 UDMA100 controller> port
0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0x1860-0x186f mem
0xe8000000-0xe80003ff at device 31.1 on pci0
ata0: <ATA channel 0> on atapci0
ata1: <ATA channel 1> on atapci0
pci0: <serial bus, SMBus> at device 31.3 (no driver attached)
pcm0: <Intel ICH3 (82801CA)> port 0x1c00-0x1cff,0x18c0-0x18ff irq 9 at
device 31.5 on pci0
pcm0: [GIANT-LOCKED]
pcm0: <Yamaha YMF753 AC97 Codec>
pci0: <simple comms, generic modem> at device 31.6 (no driver attached)
acpi_tz0: <Thermal Zone> on acpi0
atkbdc0: <Keyboard controller (i8042)> port 0x60,0x64 irq 1 on acpi0
atkbd0: <AT Keyboard> irq 1 on atkbdc0
kbd0 at atkbd0
atkbd0: [GIANT-LOCKED]
psm0: <PS/2 Mouse> irq 12 on atkbdc0
psm0: [GIANT-LOCKED]
psm0: model Generic PS/2 mouse, device ID 0
ppc0: <ECP parallel printer port> port 0x378-0x37f,0x778-0x77f irq 7 drq
3 on acpi0
ppc0: SMC-like chipset (ECP/EPP/PS2/NIBBLE) in COMPATIBLE mode
ppc0: FIFO with 16/16/15 bytes threshold
ppbus0: <Parallel port bus> on ppc0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
acpi_sony0: <Sony notebook controller> on acpi0
acpi_sony0: PID 0
battery0: <ACPI Control Method Battery> on acpi0
battery1: <ACPI Control Method Battery> on acpi0
acpi_acad0: <AC Adapter> on acpi0
npx0: [FAST]
npx0: <math processor> on motherboard
npx0: INT 16 interface
pmtimer0 on isa0
orm0: <ISA Option ROMs> at iomem
0xc0000-0xcffff,0xd8000-0xdbfff,0xdc000-0xdffff pnpid ORM0000 on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x300>
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on
isa0
ums0: Microsoft Microsoft IntelliMouse\M-. Explorer, rev 1.10/1.21, addr
2, iclass 3/1
ums0: 5 buttons and Z dir.
ukbd0: Logitech Logitech USB Keyboard, rev 1.10/12.10, addr 2, iclass
3/1
kbd1 at ukbd0
uhid0: Logitech Logitech USB Keyboard, rev 1.10/12.10, addr 2, iclass
3/1
Timecounter "TSC" frequency 2395765528 Hz quality 800
Timecounters tick every 1.000 msec
ad0: 28615MB <FUJITSU MHR2030AT 40BA> at ata0-master UDMA100
acd0: CDRW <SONY CD-RW/DVD-ROM CRX810E/1.5a> at ata1-master PIO4
Trying to mount root from ufs:/dev/ad0s1a
pid 39699 (display), uid 1000: exited on signal 11 (core dumped)
cardbus0: <network> at device 0.0 (no driver attached)
cardbus1: <network> at device 0.0 (no driver attached)
cardbus1: <network> at device 0.0 (no driver attached)
cardbus1: <network> at device 0.0 (no driver attached)
cardbus0: <network> at device 0.0 (no driver attached)
cardbus0: <network> at device 0.0 (no driver attached)

-- 
"Any attempt to brew coffee with a teapot should result in the error
code "418 I'm a teapot".
The resulting entity body MAY be short and stout."
-- HTCPCP Spec, RFC 2324