6.0-CURRENT SNAP004 hangs on amr

[Joao Barros]

On 7/4/05, Mike Tancsa <mike at sentex.net> wrote:
> At 02:18 PM 02/07/2005, Martin Nilsson wrote:
> >Joao Barros wrote:
> >>I was trying to install 6.0-CURRENT SNAP004 i386 from CD and the
> >>kernel hangs on amr.
> >>I tried setting hint.acpi.0.disabled=1 with no change.
> >>Removing the card the kernel boots right and I get to see sysinstall.
> >>FreeBSD 5.4 installs and runs fine.
> >
> >I have the same problem with a MegaRAID Elite 1600 card, the problem is
> >with interrupt routing in CURRENT. I have tested my card in both a P3 and
> >a P4/Xeon with the same result. There is a PCI-PCI bridge on these cards,
> >I think that it is the cause of this problem as the 320-1 works as it should.
> 
> I think I too am seeing this on a 4way PIII
> 
> Is there a work around ?
> 
>          ---Mike
 
I tried SNAP005 after Scott's post and still no luck.
I'm trying this on a single PIII Supermicro 370SSR and disabled most
unused devices (parallel, com2, onboard scsi, secondary IDE, fdc) to
try conserve IRQs.

--

João Barros