if_dc panics with 3Com OfficeConnect 10/100B PCI

Giorgos Keramidas keramida at freebsd.org
Tue Aug 16 16:18:29 GMT 2005


On 2005-08-16 09:22, "M. Warner Losh" <imp at bsdimp.com> wrote:
> In message: <20050816124525.GA31411 at flame.pc>
>             Giorgos Keramidas <keramida at freebsd.org> writes:
> : I've recently acquired a 3Com 3CSOHO100B-TX NIC, which seems to be supported
> : by the ``dc'' driver.  The output of pciconf is:
> :
> : % none0 at pci0:10:0:        class=0x020000 card=0x930010b7 chip=0x930010b7 rev=0x31 hdr=0x00
> : %     vendor   = '3COM Corp, Networking Division'
> : %     device   = '3C910 Integrated Fast Ethernet Controller (3CSOHO100B-TX Compatible)'
> : %     class    = network
> : %     subclass = ethernet
> :
> : When I compile the ``dc'' driver into my kernel or load it as a module
> : though, a relatively recent CURRENT (updated yesterday, 14 Aug 2005)
> : panics after a port mapping failure.
> :
> : The same panic happens when the device is configured into the kernel or
> : when I kldload if_dc.  Is anyone else using ``dc'' interfaces on CURRENT
> : and seeing similar problems?
>
> Trace?

It's a bit tricky, since I have to either copy it manually from the
console or find out how I can boot the machine with the NIC in serial
console mode.

Booting with 'dc' compiled into the kernel doens't quite work, since the
panic happens too early for dumpdev to be set.  If there a way to set
dumpdev earlier than /etc/rc.conf (i.e. from the boot loader)?

Using a module doesn't really help with obtaining a trace, because the
symbols of the module are printed as ??? in kgdb.

I'll try to obtain a trace later tonight though.  Thanks for the reply :)

- Giorgos



More information about the freebsd-current mailing list