ad0: TIMEOUT - WRITE_DMA retrying (2 retries left) LBA=xxx

Tristan tris at
Thu Sep 30 17:58:18 PDT 2004

On Thu, 30 Sep 2004 20:52:27 -0400
Ken Smith <kensmith at cse.Buffalo.EDU> wrote:
> On Fri, Oct 01, 2004 at 09:35:15AM +0930, Tristan wrote:
> > FreeBSD 6.0-CURRENT with GENERIC kernel built 27th Sep.
> > On a SunBlade 100 I see these messages regularly when
> > dma is enabled. The messages go away when I either use
> > atacontrol to set the mode to PIO4 or set hw.ata.ata_dma to 0
> > I do get data corruption on the disk if left in DMA mode.
> Just FYI my primary test machine is a SunBlade 100, it seems to
> be doing OK with a kernel built from this morning's source.  I've
> been doing most of my builds from an NFS server though, I'll do
> a check with a full buildworld which will use the local drive more.
> > ad0: 14594MB <ST315310A/3.28> [29651/16/63] at ata2-master UDMA66
> > acd0: CDRW <LTN486S/YSU1> at ata2-slave PIO4
> > ata3-master: DMA limited to UDMA33, non-ATA66 cable or device
> > ad1: 39266MB <IBM-DTLA-305040/TW4OA60A> [79780/16/63] at ata3-master UDMA33
> > Mounted root from ufs:/dev/ad0a.
> Is the data corruption spread across both drives, or just ad1?  That
> message about the cable or device being limited could be a clue.

nope, its only on ad0. ad1 seems to be fine, however it is hardly used.

More information about the freebsd-current mailing list