fxp0: device timeout
Tony Maher
tonymaher at optushome.com.au
Fri May 28 21:11:20 PDT 2004
Hello,
(on compaq Evo N610c)
I just ran cvsup and did make world. All seemed ok, after make installkernel
reboot I did my usual ping test to make sure network was ok before running
installworld/mergemaster. However after I had been logged in for no
more than a couple of minutes my usb mouse froze and console gave
fxp0: device timeout
and no network response. THe usb mouse and fxp0 share the same interrupt
so I removed mouse and rebooted. Same problem. Network initially works
(can scp a few meg) but dies soon after login.
I have reverted back to older kernel (may 23) but still running latest
userland and everything seems fine. I'll plan to cvsup to earlier date
and rebuild world to a consistent state but probably
wont get to do this till tomorrow.
from current setup
vmstat -i
interrupt total rate
irq0: clk 72368 99
irq1: atkbd0 2968 4
irq6: fdc0 5 0
irq8: rtc 92629 127
irq10: fxp0 ohci0++ 38484 53
irq11: cbb0 cbb1++ 42139 58
irq12: psm0 54 0
irq13: npx0 1 0
irq14: ata0 13551 18
irq15: ata1 36 0
Total 262235 361
--
tonym
More information about the freebsd-current
mailing list