ISDN4BSD broken...
Matthias Schuendehuette
msch at snafu.de
Sat Aug 14 09:54:42 PDT 2004
Hi all,
I just rebooted into the new cuurent-kernel and found, that i4b isn't
working any more. Last working kernel was of Aug 11, around 1800 UTC.
Aug 14 18:19:46 current kernel: FreeBSD 5.2-CURRENT #0: \
Sat Aug 14 17:43:56 CEST 2004
[...]
Aug 14 18:19:46 current kernel: ACPI link \_SB_.PCI0.LNKA \
has invalid initial irq 9, ignoring
(this is a new message, which doesn't show up with my Aug 11 kernel)
[...]
Aug 14 18:19:46 current kernel: isic0: [GIANT-LOCKED]
Aug 14 18:19:46 current kernel: isic0 at port \
0x580-0x59f,0x180-0x19f,0x980-0x99f,0xd80-0xd9f \
irq 10 flags 0x3 on isa0
Aug 14 18:19:46 current kernel: isic0: passive stack unit 0
Aug 14 18:19:46 current kernel: isic0: Teles S0/16.3
[...]
Aug 14 18:19:46 current kernel: i4bisppp: \
2 ISDN SyncPPP device(s) attached
Aug 14 18:19:46 current kernel: i4b: \
ISDN call control device attached
Aug 14 18:19:46 current kernel: i4btrc: \
1 ISDN trace device(s) attached
Aug 14 18:19:46 current kernel: i4brbch: \
2 raw B channel access device(s) attached
Aug 14 18:19:46 current kernel: i4btel: \
2 ISDN telephony interface device(s) attached
Aug 14 18:19:46 current kernel: i4bipr: \
2 IP over raw HDLC ISDN device(s) attached (VJ header compression)
Aug 14 18:19:46 current kernel: i4bctl: \
ISDN system control port attached
So far, the ISDN-Card is detected and attached as usual, but if I try to
dial out, the following messages were recorded:
Aug 14 18:22:25 current kernel: i4b-L1 timer3_expired: \
state = F4 Awaiting Signal
Aug 14 18:22:25 current kernel: i4b-L1 isic_recover: \
HSCX B: ISTA = 0x0
Aug 14 18:22:25 current kernel: i4b-L1 isic_recover: \
ISAC: ISTA = 0x94
Aug 14 18:22:25 current kernel: i4b-L1 isic_recover: \
ISAC: CISQ = 0x1e
Aug 14 18:22:25 current kernel: i4b-L1 isic_recover: \
HSCX B: IMASK = 0xff
Aug 14 18:22:25 current kernel: i4b-L1 isic_recover: \
HSCX A: IMASK = 0xf8
Aug 14 18:22:25 current kernel: i4b-L1 isic_recover: \
ISAC: IMASK = 0x2a
Aug 14 18:22:25 current kernel: i4b-L2 i4b_T202_timeout: \
unit 0, N202 = 3
Aug 14 18:22:25 current kernel: i4b-L1 isic_ph_data_req: \
still in state F3!
Aug 14 18:22:27 current kernel: i4b-L3 T303_timeout: \
SETUP not answered, cr = 15
Aug 14 18:22:27 current kernel: i4b-L3 next_l3state: \
FSM illegal state, state = ST_OW - Out Wait EST, \
event = EV_T303EXP - T303 timeout!
Aug 14 18:22:27 current kernel: i4b-L1 timer3_expired: \
state = F4 Awaiting Signal
Aug 14 18:22:27 current kernel: i4b-L1 isic_recover: \
HSCX B: ISTA = 0x0
Aug 14 18:22:27 current kernel: i4b-L1 isic_recover: \
ISAC: ISTA = 0x4
Aug 14 18:22:27 current kernel: i4b-L1 isic_recover: \
ISAC: CISQ = 0x32
Aug 14 18:22:27 current kernel: i4b-L1 isic_recover: \
HSCX B: IMASK = 0xff
Aug 14 18:22:27 current kernel: i4b-L1 isic_recover: \
HSCX A: IMASK = 0xf8
Aug 14 18:22:27 current kernel: i4b-L1 isic_recover: \
ISAC: IMASK = 0x2a
Any ideas? ACPI or IRQ-Routing related?
--
Ciao/BSD - Matthias
Matthias Schuendehuette <msch [at] snafu.de>, Berlin (Germany)
PGP-Key at <pgp.mit.edu> and <wwwkeys.de.pgp.net> ID: 0xDDFB0A5F
More information about the freebsd-current
mailing list