Adaptec AIC7902 Ultra320 Problems

[Lawrence Farr]

OK, gave that a go, and still the same. Im assuming you meant
to set it to 160 in the Adaptec bios? It shows up as 160Mb 
transfers in the dmesg now.

Any other ideas I can try?

Lawrence Farr
EPC Direct Limited 

> -----Original Message-----
> From: Sergey A. Osokin [mailto:osa at FreeBSD.org] 
> Sent: 22 July 2003 13:43
> To: Lawrence Farr
> Cc: current at freebsd.org
> Subject: Re: Adaptec AIC7902 Ultra320 Problems
> 
> 
> On Tue, Jul 22, 2003 at 01:23:18PM +0100, Lawrence Farr wrote:
> > I have a Supermicro SuperServer 6013P-8, with:
> > 
> > ahd0: <Adaptec AIC7902 Ultra320 SCSI adapter> port
> > 0x4000-0x40ff,0x4400-0x44ff mem 0xfc300000-0xfc301fff irq 5 
> at device 2.0 on
> > pci3
> > aic7902: Ultra320 Wide Channel A, SCSI Id=7, PCI-X 
> 101-133Mhz, 512 SCBs
> > ahd1: <Adaptec AIC7902 Ultra320 SCSI adapter> port
> > 0x4800-0x48ff,0x4c00-0x4cff mem 0xfc302000-0xfc303fff irq 5 
> at device 2.1 on
> > pci3
> > aic7902: Ultra320 Wide Channel B, SCSI Id=7, PCI-X 
> 101-133Mhz, 512 SCBs
> > 
> > Trying to install 5.1-CURRENT-20030709-JPSNAP or 4.8-STABLE on the
> > box gives a timeout error that will hang the disk in a state that
> > resetting the machine does not clear, and only power cycling will
> > clear. Ive replaced the disks with no change, but installed and
> > ran Redhat 7.3 on the box with no timeouts or errors.
> > 
> > The full dmesg is here:
> > http://aticatac.epcdirect.co.uk/~l.farr/6013P8_dmesg.txt
> > 
> > And timeout is here:
> > http://aticatac.epcdirect.co.uk/~l.farr/AIC7902_timeout.txt
> 
> Try to switch your adapter from Ultra320 to Ultra160 mode, then
> try to install again.
> 
> -- 
> 
> Rgdz,                        /"\  ASCII RIBBON CAMPAIGN
> Sergey Osokin aka oZZ,       \ /    AGAINST HTML MAIL
> http://ozz.pp.ru/             X          AND NEWS
>                              / \
>