[Bug 242008] Installation on BananaPi fails: mmc0: Failed to set VCCQ for card at relative address 1

bugzilla-noreply at freebsd.org bugzilla-noreply at freebsd.org
Fri Dec 20 15:36:28 UTC 2019


https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=242008

--- Comment #2 from Helmut <helmut.schlattl at web.de> ---
I booted FreeBSD-12.1 verbosely and with kern.smp.disabled=1 and got the
following output in the serial console:

usbus0: 480Mbps High Speed USB v2.0
usbus1: 12Mbps Full Speed USB v1.0
usbus2: 480Mbps High Speed USB v2.0
usbus3: 12Mbps Full Speed USB v1.0
axp2xx_pmu0: Powered by AC
aw_mmc0: Powering up sd/mmc
mmc0: Probing bus
ugen0.1: <Allwinner EHCI root HUB> at usbus0
uhub0: <Allwinner EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> on usbus0
ugen1.1: <Generic OHCI root HUB> at usbus1
uhub1: <Generic OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus1
ugen2.1: <Allwinner EHCI root HUB> at usbus2
uhub2: <Allwinner EHCI root HUB, class 9/0, rev 2.00/1.00, addr 1> on usbus2
ugen3.1: <Generic OHCI root HUB> at usbus3
uhub3: <Generic OHCI root HUB, class 9/0, rev 1.00/1.00, addr 1> on usbus3
mmc0: SD 2.0 interface conditions: OK
mmc0: SD probe: OK (OCR: 0x00ff8000)
mmc0: Current OCR: 0x00ff8000
mmc0: Probing cards
mmc0: New card detected (CID 2842454e4434474221562a275e0107e7)
mmc0: New card detected (CSD 400e00325b5900001ddd7f800a4000e9)
mmc0: Card at relative address 0x59b4 added:
mmc0:  card: SDHC ND4GB 2.1 SN 562A275E MFG 07/2016 by 40 BE
mmc0:  quirks: 0
mmc0:  bus: 4bit, 50MHz (high speed timing)
mmc0:  memory: 7829504 blocks, erase sector 8192 blocks
mmc0: setting transfer rate to 50.000MHz (high speed timing)
mmcsd0: 4GB <SDHC ND4GB 2.1 SN 562A275E MFG 07/2016 by 40 BE> at mmc0
50.0MHz/4bit/32768-block
regulator: shutting down vcc3v0
regulator: shutting down vcc3v3
regulator: shutting down vcc5v0
regulator: shutting down ldo3
Trying to mount root from ufs:/dev/ufs/rootfs [rw]...
GEOM: new disk mmcsd0
mmc0: setting bus width to 4 bits high speed timing
mmc0: Failed to set VCCQ for card at relative address 22964
GEOM_PART: partition 1 on (mmcsd0, MBR) is not aligned on 4194304 bytes
GEOM_PART: partition 2 on (mmcsd0, MBR) is not aligned on 4194304 bytes
aw_mmc0: error rint:

-- 
You are receiving this mail because:
You are the assignee for the bug.


More information about the freebsd-bugs mailing list