[Bug 209468] aacraid run_interrupt_driven_hooks: still waiting after 60-300 seconds for xpt_config panic

[bugzilla-noreply at freebsd.org]

https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=209468

--- Comment #22 from Maxim <admin at maxnet.ua> ---
Hi All!

   I checked the patch on FreeBSD 10.3R, the bug is fixed and the controller is
work fine on new firmware. In the previously proposed patch there were
inconsistencies, because of what it was not applied:
Hunk #11 failed at 2921.
Hunk #12 succeeded at 3702 (offset -10 lines).
Hunk #13 succeeded at 3746 (offset -10 lines).
Hunk #14 succeeded at 3812 (offset -10 lines).

I was corrected patch, file in attachment.

   Test hardware:
Adaptec ASR8805
   BIOS                                     : 7.11-0 (33173)
   Firmware                                 : 7.11-0 (33173)
   Driver                                   : 3.2-10 (1)
   Boot Flash                               : 7.11-0 (33173)
   CPLD (Load version/ Flash version)       : 6/ 11
   SEEPROM (Load version/ Flash version)    : 1/ 1

Driver:
aacraid0: <Adaptec RAID Controller> port 0xe000-0xe0ff mem
0xfb100000-0xfb1fffff,0xfb280000-0xfb2803ff irq 42 at device 0.0 on pci4
aacraid0: Enable Raw I/O
aacraid0: Enable 64-bit array
aacraid0: using MSI-X interrupts (32 vectors)
aacraid0: New comm. interface type2 enabled
aacraid0: ASR8805, aacraid driver 3.2.10-1
aacraidp0 on aacraid0
aacraidp1 on aacraid0
aacraidp2 on aacraid0
aacraidp3 on aacraid0

-- 
You are receiving this mail because:
You are the assignee for the bug.