Pine64+ latest image hangs

Sat Feb 10 11:35:53 UTC 2018

I flashed FreeBSD-12.0-CURRENT-arm64-aarch64-PINE64-20180208-r329009.img to a 
16GB SD card and booted it with my Ping64+ 2GB unit. It boots, but then hangs 
as follows (*not* in verbose mode, though):

>> FreeBSD EFI boot block
   Loader path: /boot/loader.efi

   Initializing modules: ZFS UFS
   Load Path: \efi\boot\bootaa64.efi
   Load Device: mmc0
   BootCurrent: 0000
   BootOrder: 0018 0000 0000 0000 88f0 b9f3 0000 0000 8000 bdfb 0000 0000 0001 
0
000 0000 0000 0000 4800 0000 0000 2ce0 b9f3 0000 0000 6624 bdf6 0000 0000 e053 
b
8f1 0000 0000 0001 0000 0000 0000 2dc8 b9f3 0000 0000 e020 b8f1 0000 0000 0033 
0
000 0000 0000 2dc8 b9f3 0000 0000 6bc8 bdfa 0000 0000 6000 bdfb 0000 0000 ff58 
b
8f1 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 0000 2d40 
b
9f3 0000 0000 4eac bdf9 0000 0000 f5e6 bdfa 0000 0000 0000 0000 0000 0000 0018 
0
000 0000 0000 e038 b8f1 0000 0000
   Probing 3 block devices.....* done
    ZFS found no pools
    UFS found 1 partition
Consoles: EFI console  
Command line arguments: loader.efi
Image base: 0xb6db2008
EFI version: 2.05
EFI Firmware: Das U-boot (rev 0.00)

FreeBSD/arm64 EFI loader, Revision 1.1
(Fri Feb  9 03:18:19 UTC 2018 root at releng3.nyi.freebsd.org)
Loading /boot/defaults/loader.conf
/boot/kernel/kernel text=0x839481 data=0xb22d0+0x447f4c 
syms=[0x8+0x111648+0x8+0
x103c15]
|
Hit [Enter] to boot immediately, or any other key for command prompt.
Booting [/boot/kernel/kernel]...               
Using DTB provided by EFI at 0x48000000.
KDB: debugger backends: ddb
KDB: current backend: ddb
Copyright (c) 1992-2018 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 12.0-CURRENT #0 r329009: Fri Feb  9 03:21:22 UTC 2018
    root at releng3.nyi.freebsd.org:/usr/obj/usr/src/arm64.aarch64/sys/GENERIC 
arm6
4
FreeBSD clang version 6.0.0 (branches/release_60 324090) (based on LLVM 6.0.0)
WARNING: WITNESS option enabled, expect reduced performance.
VT: init without driver.
module_register: cannot register gic/gicv2m from kernel; already loaded from 
ker
nel
Module gic/gicv2m failed to register: 17
Starting CPU 1 (1)
Starting CPU 2 (2)
Starting CPU 3 (3)
FreeBSD/SMP: Multiprocessor System Detected: 4 CPUs
arc4random: no preloaded entropy cache
module_register_init: MOD_LOAD (efirt, 0xffff000000103c48, 0) error 12
random: entropy device external interface
kbd0 at kbdmux0
ofwbus0: <Open Firmware Device Tree>
clk_fixed0: <Fixed clock> on ofwbus0
clk_fixed1: <Fixed clock> on ofwbus0
clk_fixed2: <Fixed clock> on ofwbus0
simplebus0: <Flattened device tree simple bus> on ofwbus0
aw_ccung0: <Allwinner Clock Control Unit NG> mem 0x1c20000-0x1c203ff on 
simplebu
s0
iichb0: <Allwinner Integrated I2C Bus Controller> mem 0x1c2b000-0x1c2b3ff irq 
21
 on simplebus0
iicbus0: <OFW I2C bus> on iichb0
aw_ccung1: <Allwinner Clock Control Unit NG> mem 0x1f01400-0x1f014ff on 
simplebu
s0
regfix0: <Fixed Regulator> on ofwbus0
psci0: <ARM Power State Co-ordination Interface Driver> on ofwbus0
awusbphy0: <Allwinner USB PHY> mem 
0x1c19400-0x1c19413,0x1c1a800-0x1c1a803,0x1c1
b800-0x1c1b803 on simplebus0
gic0: <ARM Generic Interrupt Controller> mem 0x1c81000-0x1c81fff,
0x1c82000-0x1c8
3fff,0x1c84000-0x1c85fff,0x1c86000-0x1c87fff irq 23 on simplebus0
gic0: pn 0x2, arch 0x2, rev 0x1, implementer 0x43b irqs 224
gpio0: <Allwinner GPIO/Pinmux controller> mem 0x1c20800-0x1c20bff irq 12,13,14 
o
n simplebus0
gpiobus0: <OFW GPIO bus> on gpio0
gpio1: <Allwinner GPIO/Pinmux controller> mem 0x1f02c00-0x1f02fff irq 26 on 
simp
lebus0
gpiobus1: <OFW GPIO bus> on gpio1
generic_timer0: <ARMv8 Generic Timer> irq 0,1,2,3 on ofwbus0
Timecounter "ARM MPCore Timecounter" frequency 24000000 Hz quality 1000
Event timer "ARM MPCore Eventtimer" frequency 24000000 Hz quality 1000
rtc0: <Allwinner RTC> mem 0x1f00000-0x1f00053 irq 24,25 on simplebus0
rtc0: registered as a time-of-day clock, resolution 1.000000s
cpulist0: <Open Firmware CPU Group> on ofwbus0
cpu0: <Open Firmware CPU> on cpulist0
cpu1: <Open Firmware CPU> on cpulist0
cpu2: <Open Firmware CPU> on cpulist0
cpu3: <Open Firmware CPU> on cpulist0
aw_mmc0: <Allwinner Integrated MMC/SD controller> mem 0x1c0f000-0x1c0ffff irq 
4 
on simplebus0
mmc0: <MMC/SD bus> on aw_mmc0
ehci0: <Allwinner Integrated USB 2.0 controller> mem 0x1c1b000-0x1c1b0ff irq 
10 
on simplebus0
usbus0: EHCI version 1.0
usbus0 on ehci0
ohci0: <Generic OHCI Controller> mem 0x1c1b400-0x1c1b4ff irq 11 on simplebus0
usbus1 on ohci0
gpioc0: <GPIO controller> on gpio0
uart0: <16750 or compatible> mem 0x1c28000-0x1c283ff irq 15 on simplebus0
uart0: console (115384,n,8,1)
iic0: <I2C generic I/O> on iicbus0
gpioc1: <GPIO controller> on gpio1
awg0: <Allwinner Gigabit Ethernet> mem 0x1c30000-0x1c31fff,0x1c00030-0x1c00033 
i
rq 27 on simplebus0
miibus0: <MII bus> on awg0
rgephy0: <RTL8169S/8110S/8211 1000BASE-T media interface> PHY 0 on miibus0
rgephy0:  none, 10baseT, 10baseT-FDX, 10baseT-FDX-flow, 100baseTX, 100baseTX-
FDX
, 100baseTX-FDX-flow, 1000baseT, 1000baseT-master, 1000baseT-FDX, 1000baseT-
FDX-
master, 1000baseT-FDX-flow, 1000baseT-FDX-flow-master, auto, auto-flow
rgephy1: <RTL8169S/8110S/8211 1000BASE-T media interface> PHY 1 on miibus0
rgephy1:  none, 10baseT, 10baseT-FDX, 10baseT-FDX-flow, 100baseTX, 100baseTX-
FDX
, 100baseTX-FDX-flow, 1000baseT, 1000baseT-master, 1000baseT-FDX, 1000baseT-
FDX-
master, 1000baseT-FDX-flow, 1000baseT-FDX-flow-master, auto, auto-flow
awg0: Ethernet address: 02:ba:3c:df:77:89
cryptosoft0: <software crypto>
Timecounters tick every 1.000 msec
usbus0: 480Mbps High Speed USB v2.0
usbus1: 12Mbps Full Speed USB v1.0

CTRL-A Z for help | 115200 8N1 | NOR | Minicom 2.7.1 | VT102 | Offline | cuaU0 

It then sits there, unresponsive. I've tried sending break on the serial 
console, but get no response that way either.

[ade]
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 228 bytes
Desc: This is a digitally signed message part.
URL: <http://lists.freebsd.org/pipermail/freebsd-arm/attachments/20180210/4d544fc7/attachment.sig>