Can't use mge on 88F5181

[Mori Hiroki]

Hi.

No arp and unicast packet receive mge checked by tcpdump command
on this target. Also no pacet trans checked by tcpdump command on
other machine. netstat -i have trans packet count without error.
But no receive other machine. MIDO switch control is work fine.
Giga switch physical port to physical port is receive and trans
is fine. But cpu port nothing.

My e6060sw.c code have dot1q support by VTU access code. e6000sw
don't have it. I want add dot1q code to e6000sw too. But It is
very hard no data sheet.

I found ml topics is this type target at 2011. That subject is 
"Embedded switch instead of stadard PHY". I seem this is origin
of etherswitch.

Thanks

Hiroki Mori


----- Original Message -----
> From: Adrian Chadd <adrian.chadd at gmail.com>
> To: Mori Hiroki <yamori813 at yahoo.co.jp>
> Cc: "freebsd-arm at freebsd.org" <freebsd-arm at freebsd.org>
> Date: 2017/4/12, Wed 09:55
> Subject: Re: Can't use mge on 88F5181
> 
> hiya,
> 
> did you figure it out?
> 
> Is there something like CRC, etc packet errors or something on RX?
> 
> 
> 
> -adrian
> 
> 
> On 4 April 2017 at 04:42, Mori Hiroki <yamori813 at yahoo.co.jp> wrote:
>>  Hi.
>> 
>>  I try to use Buffalo WZR-AMPG300NH. This module have 88F5181 and 88E6131.
>>  I modify dev/mge and dev/etherswitch/e600sw/e6000sw.c.
>> 
>>  Network interface mge is detect but not work. Switch port is work by
>>  port vlan. But CPU connected port3 is nothing trans and receive packet.
>> 
>>  I check marvell code but not fix this problem.
>> 
>>  If you have advice, please let me know.
>> 
>> 
>>  This is dmesg.
>> 
>>  https://gist.github.com/yamori813/ecd5df1b314053a73f310c1122775540
>> 
>> 
>>  Thanks.
>> 
>>  Hiroki Mori
>>  _______________________________________________
>>  freebsd-arm at freebsd.org mailing list
>>  https://lists.freebsd.org/mailman/listinfo/freebsd-arm
>>  To unsubscribe, send any mail to 
> "freebsd-arm-unsubscribe at freebsd.org"
>