RPI-B as router

[Alexey V. Panfilov]

22.03.2013 09:09, Tim Kientzle wrote:
> On Mar 21, 2013, at 8:04 AM, Alexey V. Panfilov wrote:
>>
>> I decide to test RRI-B as simple router (without NAT): [Host A] ---
>> [RPI-B] --- [Host B]
>> ...
>> So RPI-B network's throughput was around 20Mbit/sec of full-duplex traffic:
> 
> Have you tried it with Linux?  If Linux is about the same
> speed, then it's probably a hardware limitation.

No, I haven't tried it with Linux yet.

> 
>> gpu_mem=8Mb
>> FreeBSD 10.0-CURRENT r248554
>> Kernel's config (original RPI-B) was modified by commented out
>>
>> #makeoptions    MODULES_OVERRIDE=""
> 
> Did you remove WITNESS and INVARIANTS ?
> 
> They make a huge difference to overall system performance.
> 

Yes, I've test it with removed INVARIANTS - result was the same.
WITNESS is not present at /sys/arm/conf/RPI-B

>> Ipfw has one rule - allow ip from any to any
> 
> Did it make a difference if you disabled ipfw?

No, I've not test it with disabled ipfw .

> Tim
> 


-- 
Best regards,
Alexey V. Panfilov