Unable to copy DTB into module directory

Werner Thie werner at thieprojects.ch
Fri Feb 22 07:13:48 UTC 2013


On 2/22/13 8:07 AM, Alie Tan wrote:
>
> On Fri, Feb 22, 2013 at 2:57 PM, Werner Thie <werner at thieprojects.ch
> <mailto:werner at thieprojects.ch>> wrote:
>
>     On 2/22/13 7:47 AM, Alie Tan wrote:
>
>         On Fri, Feb 22, 2013 at 2:17 PM, Tim Kientzle <tim at kientzle.com
>         <mailto:tim at kientzle.com>> wrote:
>
>
>             On Feb 21, 2013, at 10:07 PM, Tim Kientzle wrote:
>
>                 On Feb 21, 2013, at 9:50 PM, Alie Tan wrote:
>
>
>                     I just built RasPi image and keeps getting this message:
>
>                     "unable to copy DTB into module directory"
>
>                     then the raspi reboot again and again.
>
>
>                 Try backing out r247045 and see if that fixes
>                 it for you.
>
>                 Also try breaking into the U-Boot prompt
>                 and entering
>
>
>             Sorry, left out some steps here.  (To clarify, this is a
>             separate
>             experiment to be done with an image that includes
>             r247045).  The instructions should say:
>
>                 1) Remove the "fdt addr 0x100" command from loader.rc
>
>                 2) Early in boot, break to the U-Boot prompt (hit any
>             key during the
>             3-second countdown)
>
>         I can't even hit any key on my keyboard. What to do now?
>
>
>     Are you on USB/serial console? 256MB RPi? No reset button?
>
>
> I am on video console connected to HDMI, 512MB RPI
>
>     If so, it's very tricky to bring cu up and sneak in a keystroke (not
>     ENTER though)
>
>     Fiddling with the power and cu usually takes a few attempts for me
>
>     Werner
>
>
Hmm, sorry - never used that HDMI output so far, I'm on serial console

Werner


More information about the freebsd-arm mailing list