MiataGL doesn't boot in 5.4-RC2

[Bernd Walter]

On Tue, Apr 12, 2005 at 11:06:55PM +0200, Wilko Bulte wrote:
> On Tue, Apr 12, 2005 at 10:51:05PM +0200, Bernd Walter wrote..
> > On Tue, Apr 12, 2005 at 10:13:50PM +0200, Victor Balada Diaz wrote:
> > > When i try to boot the bootonly cd of FreeBSD 5.4-RC2 it hangs forever after
> > > probing the isp(4) card.
> > > 
> > > >>>show conf
> > > 
> > > 
> > >      Bus 00  Slot 20: DECchip 21152 PCI to PCI Bridge
> > >        Bus 01  Slot 04: ISP1040 Scsi Controller
> > >                                    pkc0.7.0.1004.0       SCSI Bus ID 7       
> > >                                    dkc0.0.0.1004.0        RZ2CC-KB            
> > >                                    dkc100.1.0.1004.0      SEAGATE ST39175LW   
> > 
> > Put the isp card into a 64 bit slot.
> 
> Miata GL has onboard isp(4) SCSI.  Miata MX5 does not.

Ah - mixed those up.

> That said, any relation that you can think of with interrupt routing?

No - there is a problem on MX5, but in this case the bridge setup
looks correct.
If there are problems with int routing then they should be limited
to add-on hardware, not standard.
All I know about is that there are problems with the cypress
controller, which very likely still exists.

> > Would be interesting to see what happens with your IDE controller.
> 
> Yup...

Are there any other models with Cypress chips?
I think most in that time range had CMD646 ones.

-- 
B.Walter                   BWCT                http://www.bwct.de
bernd at bwct.de                                  info at bwct.de