[Bug 234676] Boot hangs after upgrade to 12.0-RELEASE (acpi?)
bugzilla-noreply at freebsd.org
bugzilla-noreply at freebsd.org
Sat Jan 12 19:54:17 UTC 2019
https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=234676
--- Comment #5 from johan van Zanten <johanvz816 at giantfoo.org> ---
I noticed the traceback was similar to 222908 and so i tried adding this to
/boot/loader.conf:
machdep.disable_msix_migration=1
The next boot of the 12.0-RELEASE kernel did get further before hanging. Below
is the output up to the hang of verbose boot. I may be missing some from the
top. Sending a break (via tip's ~#) does not drop to the debugger -- it just
prints one "~" the screen. :(
0x0000000000103000 - 0x00000000001fffff, 1036288 bytes (253 pages)
0x0000000002800000 - 0x00000000bdd8ffff, 3143172096 bytes (767376 pages)
0x0000000100000000 - 0x0000000231aaefff, 5128253440 bytes (1252015 pages)
avail memory = 8238747648 (7857 MB)
intel stolen mem: base 0xbe000000 size 32 MB
MADT: Found CPU APIC ID 0 ACPI ID 1: enabled
SMP: Added CPU 0 (AP)
MADT: Found CPU APIC ID 1 ACPI ID 2: enabled
SMP: Added CPU 1 (AP)
MADT: Found CPU APIC ID 2 ACPI ID 3: enabled
SMP: Added CPU 2 (AP)
MADT: Found CPU APIC ID 3 ACPI ID 4: enabled
SMP: Added CPU 3 (AP)
Event timer "LAPIC" quality 100
LAPIC: ipi_wait() us multiplier 64 (r 4100088 tsc 2660056792)
ACPI APIC Table: <060410 APIC1553>
Package ID shift: 2
L2 cache ID shift: 1
L1 cache ID shift: 0
Core ID shift: 0
INTR: Adding local APIC 1 as a target
INTR: Adding local APIC 2 as a target
INTR: Adding local APIC 3 as a target
FreeBSD/SMP: Multiprocessor System Detected: 4 CPUs
FreeBSD/SMP: 1 package(s) x 4 core(s)
Package HW ID = 0
Core HW ID = 0
CPU0 (BSP): APIC ID: 0
Core HW ID = 1
CPU1 (AP): APIC ID: 1
Core HW ID = 2
CPU2 (AP): APIC ID: 2
Core HW ID = 3
CPU3 (AP): APIC ID: 3
APIC: CPU 0 has ACPI ID 1
APIC: CPU 1 has ACPI ID 2
APIC: CPU 2 has ACPI ID 3
APIC: CPU 3 has ACPI ID 4
x86bios: IVT 0x000000-0x0004ff at 0xfffff80000000000
x86bios: SSEG 0x010000-0x010fff at 0xfffffe00025ec000
x86bios: EBDA 0x08e000-0x09ffff at 0xfffff8000008e000
x86bios: ROM 0x0a0000-0x0fefff at 0xfffff800000a0000
Pentium Pro MTRR support enabled
random: read 3840 bytes from preloaded cache
random: unblocking device.
arc4random: read 32 bytes from preloaded cache
VIMAGE (virtualized network stack) enabled
ULE: setup cpu 0
ULE: setup cpu 1
ULE: setup cpu 2
ULE: setup cpu 3
ACPI: RSDP 0x00000000000FA620 000014 (v00 ACPIAM)
ACPI: RSDT 0x00000000BDD90000 000048 (v01 060410 RSDT1553 20100604 MSFT
00000097)
ACPI: FACP 0x00000000BDD90200 000084 (v01 060410 FACP1553 20100604 MSFT
00000097)
ACPI: DSDT 0x00000000BDD90440 007019 (v01 1AAAA 1AAAA000 00000000 INTL
20051117)
ACPI: FACS 0x00000000BDD9E000 000040
ACPI: APIC 0x00000000BDD90390 00006C (v01 060410 APIC1553 20100604 MSFT
00000097)
ACPI: MCFG 0x00000000BDD90400 00003C (v01 060410 OEMMCFG 20100604 MSFT
00000097)
ACPI: OEMB 0x00000000BDD9E040 000072 (v01 060410 OEMB1553 20100604 MSFT
00000097)
ACPI: HPET 0x00000000BDD9A440 000038 (v01 060410 OEMHPET 20100604 MSFT
00000097)
ACPI: ASF! 0x00000000BDD9A480 000099 (v32 LEGEND I865PASF 00000001 INTL
20051117)
ACPI: GSCI 0x00000000BDD9E0C0 002024 (v01 060410 GMCHSCI 20100604 MSFT
00000097)
ACPI: AWMI 0x00000000BDDA00F0 00004E (v01 060410 OEMB1553 20100604 MSFT
00000097)
ACPI: SSDT 0x00000000BDDA0820 000363 (v01 DpgPmm CpuPm 00000012 INTL
20051117)
MADT: Found IO APIC ID 4, Interrupt 0 at 0xfec00000
ioapic0: ver 0x20 maxredir 0x17
ioapic0: Routing external 8259A's -> intpin 0
MADT: Interrupt override: source 0, irq 2
ioapic0: Routing IRQ 0 -> intpin 2
MADT: Interrupt override: source 9, irq 9
ioapic0: intpin 9 trigger: level
ioapic0 <Version 2.0> irqs 0-23 on motherboard
lapic: Divisor 2, Frequency 166253561 Hz
cpu0 BSP:
ID: 0x00000000 VER: 0x00050014 LDR: 0x00000000 DFR: 0xffffffff
lint0: 0x00010700 lint1: 0x00000400 TPR: 0x00000000 SVR: 0x000001ff
timer: 0x000100ef therm: 0x00010000 err: 0x000000f0 pmc: 0x00010400
SMP: AP CPU #2 Launched!
cpu2 AP:
ID: 0x02000000 VER: 0x00050014 LDR: 0x00000000 DFR: 0xffffffff
lint0: 0x00010700 lint1: 0x00000400 TPR: 0x00000000 SVR: 0x000001ff
timer: 0x000100ef therm: 0x00010000 err: 0x000000f0 pmc: 0x00010400
SMP: AP CPU #3 Launched!
cpu3 AP:
ID: 0x03000000 VER: 0x00050014 LDR: 0x00000000 DFR: 0xffffffff
lint0: 0x00010700 lint1: 0x00000400 TPR: 0x00000000 SVR: 0x000001ff
timer: 0x000100ef therm: 0x00010000 err: 0x000000f0 pmc: 0x00010400
SMP: AP CPU #1 Launched!
cpu1 AP:
ID: 0x01000000 VER: 0x00050014 LDR: 0x00000000 DFR: 0xffffffff
lint0: 0x00010700 lint1: 0x00000400 TPR: 0x00000000 SVR: 0x000001ff
timer: 0x000100ef therm: 0x00010000 err: 0x000000f0 pmc: 0x00010400
TSC timecounter disables C2 and C3.
SMP: passed TSC synchronization test
TSC timecounter discards lower 1 bit(s)
Timecounter "TSC-low" frequency 1330028396 Hz quality 1000
wlan: <802.11 Link Layer>
random: entropy device external interface
snd_unit_init() u=0x00ff8000 [512] d=0x00007c00 [32] c=0x000003ff [1024]
feeder_register: snd_unit=-1 snd_maxautovchans=16 latency=5 feeder_rate_min=1
feeder_rate_max=2016000 feeder_rate_round=25
EFI systbl not available
[ath_hal] loaded
nfslock: pseudo-device
crypto: <crypto core>
tcp_log: tcp_log device
module_register_init: MOD_LOAD (vesa, 0xffffffff81119d50, 0) error 19
io: <I/O>
kbd: new array size 4
kbd1 at kbdmux0
mem: <memory>
netmap: loaded module
null: <full device, null device, zero device>
hpt27xx: RocketRAID 27xx controller driver v1.2.8
hptnr: R750/DC7280 controller driver v1.1.5
hptrr: RocketRAID 17xx/2xxx SATA controller driver v1.2
nexus0
vtvga0: <VT VGA driver> on motherboard
cryptosoft0: <software crypto> on motherboard
crypto: assign cryptosoft0 driver id 0, flags 0x6000000
crypto: cryptosoft0 registers alg 1 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 2 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 3 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 4 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 5 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 16 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 6 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 7 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 32 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 18 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 19 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 20 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 8 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 15 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 9 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 10 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 13 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 14 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 34 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 35 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 36 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 37 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 11 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 22 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 23 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 25 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 24 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 26 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 27 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 28 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 21 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 17 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 29 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 30 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 31 flags 0 maxoplen 0
crypto: cryptosoft0 registers alg 38 flags 0 maxoplen 0
acpi0: <060410 RSDT1553> on motherboard
ACPI: 2 ACPI AML tables successfully acquired and loaded
PCIe: Memory Mapped configuration base @ 0xe0000000
ioapic0: routing intpin 9 (ISA IRQ 9) to lapic 0 vector 48
acpi0: Power Button (fixed)
acpi0: wakeup code va 0xfffffe00025ff000 pa 0x11000
--
You are receiving this mail because:
You are on the CC list for the bug.
More information about the freebsd-acpi
mailing list