Burning Hot ASUS-6V6

[Laganakos Vassilis]

On Thu, May 03, 2007 at 02:42:01PM -0700, Nate Lawson wrote:
> Laganakos Vassilis wrote:
> > Hi,
> > 
> > I have a problem with my laptop, it gets very hot (~70C) after operating
> > for a while. I use FreeBSD-6-Stable, and it has this problem for a long
> > time now. Actually I think it always had it, but I'm fed up with this.
> > 
> > I tried various things I read in the mailing list, but I don;t know many
> > things about how acpi handles the fans to control the temperature of the
> > cpu, etc.
> 
> Try booting with acpi disabled.
> 

Ok I'll try that, but I don't know how to tell the temperature aside
from the hw.acpi.thermal.tz0.temperature

> > My sysctl hw.thermal after the changes in hw.thermal.tz0._PSV and
> > hw.thermal.user_override.
> > 
> > hw.acpi.thermal.min_runtime: 0
> > hw.acpi.thermal.polling_rate: 10
> > hw.acpi.thermal.user_override: 1
> > hw.acpi.thermal.tz0.temperature: 73.0C
> > hw.acpi.thermal.tz0.active: -1
> > hw.acpi.thermal.tz0.passive_cooling: 0
> > hw.acpi.thermal.tz0.thermal_flags: 0
> > hw.acpi.thermal.tz0._PSV: 90.0C
> > hw.acpi.thermal.tz0._HOT: -1
> > hw.acpi.thermal.tz0._CRT: 127.0C
> > hw.acpi.thermal.tz0._ACx: -1 -1 -1 -1 -1 -1 -1 -1 -1 -1
> > 
> > It seems that the device dowes not support setting passive cooling:
> > 
> > celeborn# sysctl hw.acpi.thermal.tz0.passive_cooling=1
> > hw.acpi.thermal.tz0.passive_cooling: 0
> > sysctl: hw.acpi.thermal.tz0.passive_cooling: Operation not supported by device
> > 
> > and it neither supports active:
> > 
> > celeborn# sysctl hw.acpi.thermal.tz0.active=1
> > hw.acpi.thermal.tz0.active: -1 -> -1
> > 
> > Kernel is already loaded with acpi.ko and asus_acpi.ko modules.
> > 
> > Any clues how to tackle this? I was thinking if I could set the cpu to
> > run at a lower frequency, when I'm not doing something "heavy" might
> > help.
> 
> Load the cpufreq driver at boot, add this to /boot/loader.conf:
> cpufreq_load="YES"
> 
> Then run powerd in /etc/rc.conf:
> powerd_enable="YES"
> 
> -- 
I set these out and reading how to use them.

Thank you very much! I hope that the temperature goes down, because I
feel that I'm frying my CPU (and hands)! Although ASUS-V6800V in known
about the very high temperatures it reaches...
So there is no way to do anything using the acpi driver in
FreeBSD-6-Stable?

Kind regards,

Vassilis

> Nate

--