Question regarding startup message on AIC7902

[S.C. Gehl]

Is this something I should worry about?

------
Waiting 5 seconds for SCSI devices to settle
(probe0:ahd0:0:0:0): No or incomplete CDB sent to device.
(probe0:ahd0:0:0:0): Protocol violation in Message-in phase.  Attempting to
abort.
(probe0:ahd0:0:0:0): Abort Message Sent
(probe0:ahd0:0:0:0): SCB 14 - Abort Tag Completed.
found == 0x1
(probe6:ahd0:0:6:0): No or incomplete CDB sent to device.
ahd0: Issued Channel A Bus Reset. 10 SCBs aborted
ses0 at ahd0 bus 0 target 6 lun 0
ses0: <SUPER GEM318 0> Fixed Processor SCSI-2 device
ses0: 3.300MB/s transfers
ses0: SAF-TE Compliant Device
da0 at ahd0 bus 0 target 0 lun 0
da0: <SEAGATE ST336704LC 0004> Fixed Direct Access SCSI-3 device
da0: 160.000MB/s transfers (80.000MHz, offset 63, 16bit), Tagged Queueing
Enabled
da0: 35003MB (71687369 512 byte sectors: 255H 63S/T 4462C)
da1 at ahd0 bus 0 target 1 lun 0
da1: <SEAGATE ST336704LC 0004> Fixed Direct Access SCSI-3 device
da1: 160.000MB/s transfers (80.000MHz, offset 63, 16bit), Tagged Queueing
Enabled
da1: 35003MB (71687369 512 byte sectors: 255H 63S/T 4462C)
------

--
---S.C. Gehl, 'Beauty to Burn'