Re: u-boot debug, was: Re: U-boot on RPI3, sees disk but won't boot it

From: bob prohaska <>
Date: Thu, 29 Sep 2022 02:35:04 UTC
On Wed, Sep 28, 2022 at 06:03:23PM -0700, Mark Millard wrote:
> We apparently do not have enough output enabled to see the debug
> routine's output. We are seeing the printf output.
> There might be a way to set the output message levels while at a
> U-Boot prompt, up to the maximum compiled in. But it may also be
> that we would need, say,
> instead of the 7 we are now using.

Somewhere I got the idea that 7 was max,
but I've replaced CONFIG_LOG_MAX_LEVEL=7 
with =8 in rpi_arm64_fragment and 
recompiled. It didn't make an obvious
difference, but you know better what
to look for

The output is at

The warning message "...cannot read configuration..." does not
appear in the new output and the disk isn't found anyway.
That's a bit surprising.

I just noticed there's still no log command at
the u-boot prompt. IIUC there should be. Maybe
another missing config?

Thanks for reading!

bob prohaska