[Bug 264329] print/hplip: hp-systray uses excessive CPU and does not appear in system tray // devel/py-dbus: error: dbus failed to load (python-dbus ver. 0.80+ required). Exiting...

Go to: [ bottom of page ] [ top of archives ] [ this month ]

From: <bugzilla-noreply_at_freebsd.org>
Date: Fri, 03 Jun 2022 07:48:53 UTC

https://bugs.freebsd.org/bugzilla/show_bug.cgi?id=264329

--- Comment #3 from Tijl Coosemans <tijl@FreeBSD.org> ---
(In reply to Graham Perrin from comment #2)
Is dbus enabled and running?  You can check with "service dbus status".  If it
says "Cannot status dbus" then run "service dbus enable" followed by "service
dbus start".

-- 
You are receiving this mail because:
You are on the CC list for the bug.