Replacing dead drives in ZRAID2
Simon
simon at optinet.com
Wed May 2 23:33:12 UTC 2012
On Wed, 02 May 2012 19:06:56 -0400, Daryl Richards wrote:
>One way to simulate a "failure" with ZFS is to use dd to write trash data to the
> underlying drive, and then scrub it to detect the errors and have it correct itself.
Sure, but to me this is a soft failure: the drive is still powered-on, spinning,
responding, etc... this works fine. I was trying to simulate hard failure,
drive power failure, motor broke, ECB burnt, etc... with hardware RAID
I would just yank the drive out.
-Simon
More information about the freebsd-fs
mailing list