Device IDs for HP hs2300 HSDPA modem

[Hans Petter Selasky]

On Wednesday 03 December 2008, Michael wrote:
> Hans Petter Selasky wrote:
> > On Tuesday 02 December 2008, Michael wrote:
> >> 3. I tried using a current checkout of usb2 (and added all the device
> >> IDs necessary), but serial_3g is missing (and therefore
> >>    commented out in sys/modules/usb2/Makefile), so I'm stuck there as
> >> well. Is there actual hope that the problem
> >>   might not appear when using usb2? (all I know about usb2 is that it's
> >> supposed to be giant-free, no idea if it can
> >>   handle these issues any better - seems like at least 50% of USB
> >> devices are violating the standard in one way or
> >>   another anyway).
> >
> > Alfred forgot to add the Makefile. The 3g id's are now in
> > core/usb2_msctest.c . I've sent him a patch to fix this, but have not
> > heard from him yet, assuming he is very busy.
> >
> > Just copy one of the other serial driver Makefiles and add "u3g2.c".
> >
> > --HPS
>
> Ok, essentially this seems to work, even so there are some caveats:
> 1. usb2_serial_3g has to be loaded before of usb2_controller_ehci
> 2. When I disable the device (button or bios command) it is detached
> correctly,
>    but reattaching it fails 9 out of 10 times with the following error:
> kernel: usb2_alloc_device:1421: set address 2 failed (ignored)
> kernel: usb2_alloc_device:1456: getting device descriptor at addr 2 failed!
> kernel: uhub_reattach_port:402: could not allocate new device!
>   If I kldunload usb2_controller_ehci and reload it, its detected ok.
>   usb1 has no issues performing the same operation.
> 3. The machine crashed once after reenabling the device. No crashdumps
> here, mostly because I'm stupid :(
> 4. There is only one serial device created (/dev/cuaU0), which
> represents the data interface. The control interface is not detected.
> (usb1 creates two interfaces /dev/cuaU0.0 for data and /dev/cuaU0.2 for
> control). This is essential, because even so the data interface supports
> most commands, it doesn't accept the PIN code entry cmomand (or other
> maintenance commands). For testing purposes I disabled the PIN entry
> requirement on the SIM and was able to get reasonable stable service (up
> to 250kb/s).
>
> Let me know if there is anything I can do to help debugging the issues
> above. I attached the patches for the HS2300 device.
>
> br
> michael

Hi,

Try tuning the following knobs, one at a time.

sysctl hw.usb2.ehci.no_hs=1

This will disable hooking on devices to high speed.

I think there is a problem with your device!

Another thing you can try before re-plugging:

sysctl hw.usb2.ss_delay=2

Also try:

sysctl hw.usb2.pr_recovery_delay=500

--HPS