New 'amr' driver and linux MegaMGR

[Danny Braniss]

> Cristiano Deana writes:
> [ Charset ISO-8859-1 unsupported, converting... ]
> | 2006/3/1, Paul Saab <ps at freebsd.org>:
> | > works fine
> | 
> | I got:
> |  Failed to open driver node /dev/megadev0
> 
> Make sure you have amr_linux.  kldload amr_linux.ko.  Then you should
> get a /dev/megadev0.  It also works in a static kernel.  You might
> want to do an ls -l of /dev/megadev0.  This is only available
> in FreeBSD 6.1 and -current it is not in FreeBSD 6.0.  The changes
> will drop into FreeBSD 6.0 though.

i'm getting:

Copyright (c) 1992-2006 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
        The Regents of the University of California. All rights reserved.
FreeBSD 6.1-PRERELEASE #3: Mon Feb 27 10:23:29 IST 2006
...
module_register_init: MOD_LOAD (amr_linux, 0xffffffff805f1b00, 0) error 6
ad4: 286168MB <WDC WD3000JD-00KLB0 08.05J08> at ata2-master SATA150
ad6: 286168MB <WDC WD3000JD-00KLB0 08.05J08> at ata3-master SATA150
ar0: 572072MB <LSILogic v3 MegaRAID RAID0 (stripe 16 KB)> status: READY
ar0: disk0 READY using ad4 at ata2-master
ar0: disk1 READY using ad6 at ata3-master

and no /dev/megadev0

maybe because:
atapci1 at pci0:31:2:      class=0x01048f card=0x34518086 chip=0x25b08086 rev=0x02 hdr=0x00
    vendor   = 'Intel Corporation'
    device   = '6300ESB Serial ATA Controller (RAID mode)'
    class    = mass storage
    subclass = RAID

danny