3ware firmware problem under 6.0-STABLE

[Carlos Horowicz]

Hi there,

I've built 6.0-STABLE as of today after a fresh 6.0 install on a 
Supermicro motherboard with a 3Ware 9000S-12 , and TWA_FLASH_FIRMWARE 
compiled in.

The driver went from  3.60.00.017 to  3.60.02.012 , but the firmware 
could not be written.

Here's the dmesg:

twa0: [FAST]
twa0: INFO: (0x15: 0x100c): Flashing bundled firmware...:
twa0: ERROR: (0x03: 0x0232): Binary image architecture incompatible: 
opcode=0x56
twa0: ERROR: (0x15: 0x1006): Firmware flash failed: cmd = 0x16, chunk # 
0, cmd status = 2
twa0: INFO: (0x15: 0x1017): Issuing hard (commanded) reset to the 
controller...:
twa0: WARNING: (0x15: 0x100d): Unable to flash bundled firmware. 
Attempting to work with fw on ctlr...:
twa0: INFO: (0x15: 0x1300): Controller details:: Model 9500S-12, 12 
ports, Firmware FE9X 2.04.00.005, BIOS BE9X 2.03.01.047

3ware device driver for 9000 series storage controllers, version: 
3.60.02.012
twa0: <3ware 9000 series Storage Controller> port 0x2000-0x20ff mem 
0xdd200000-0xdd2000ff,0xdf800000-0xdfffffff irq 72 at device 2.0 on pci3
da0: <3ware Logical Disk 00 1.00> Fixed Direct Access SCSI-0 device

Any ideas ?

Thanks in advance!

-Carlos