Kernel panic after upgrade to 6.0-STABLE

[Joao Barros]

You should recompile the nvidia port with the new kernel.
Boot with the driver disabled in the meantime.

On 11/5/05, Ales <ales.rom at kabelnet.net> wrote:
> Hello.
>
> After upgrade to RELENG_6, buildworld, buildkernel, installkernel,
> reboot I got this error. With 5.4 there was no problem. Can anyone see
> what is going on with this hw?
>
> Aleš
>
>
> -------------------------------------------------------------------------------------------------------------------
> Copyright (c) 1992-2005 The FreeBSD Project.
> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
> The Regents of the University of California. All rights reserved.
> FreeBSD 6.0-STABLE #0: Sat Nov 5 12:53:54 CET 2005
> romcek at romcek.FreeBSD:/usr/obj/usr/src/sys/GENERIC
> Timecounter "i8254" frequency 1193182 Hz quality 0
> CPU: AMD Sempron(tm) (2200.47-MHz 686-class CPU)
> Origin = "AuthenticAMD" Id = 0x681 Stepping = 1
> Features=0x383fbff<FPU,VME,DE,PSE,TSC,MSR,PAE,MCE,CX8,APIC,SEP,MTRR,PGE,MCA,CMOV,PAT,PSE36,MMX,FXSR,SSE>
> AMD Features=0xc0480800<SYSCALL,MP,MMX+,3DNow+,3DNow>
> real memory = 536805376 (511 MB)
> avail memory = 511782912 (488 MB)
> npx0: [FAST]
> npx0: <math processor> on motherboard
> npx0: INT 16 interface
> cpu0 on motherboard
> pcib0: <Host to PCI bridge> pcibus 0 on motherboard
> pir0: <PCI Interrupt Routing Table: 10 Entries> on motherboard
> pci0: <PCI bus> on pcib0
> pcib1: <PCI-PCI bridge> at device 1.0 on pci0
> pci1: <PCI bus> on pcib1
> nvidia0: <GeForce FX 5500> mem
> 0xde000000-0xdeffffff,0xd0000000-0xd7ffffff irq 11 at device 0.0 on pci1
> WARNING: Device driver "
>
> Fatal trap 12: page fault while in kernel mode
> fault virtual address = 0x480008
> fault code = supervisor read, page not present
> instruction pointer = 0x20:0xc07168c8
> stack pointer = 0x28:0xc102082c
> frame pointer = 0x28:0xc102082c
> code segment = base 0x0, limit 0xfffff, type 0x1b
> = DPL 0, pres 1, def32 1, gran 1
> processor eflags = interrupt enabled, resume, IOPL = 0
> current process = 0 (swapper)
> trap number = 12
> panic: page fault
> Uptime: 1s
> ---------------------------------------------------------------------
> In 5.4 the next dmesg message looks like this. So is this VIA SATA
> controller causing problem?
>
> pcib1: <PCI-PCI bridge> at device 1.0 on pci0
> pci1: <PCI bus> on pcib1
> nvidia0: <GeForce FX 5500> mem
> 0xd0000000-0xd7ffffff,0xde000000-0xdeffffff irq 16 at device 0.0 on pci1
> atapci0: <VIA 6420 SATA150 controller> port
> 0xd800-0xd8ff,0xdc00-0xdc0f,0xe000-0xe003,0xe400-0xe407,0xe800-0xe803,0xec00-0xec07
> irq 20 at device 15.0 on pci0
> ata2: channel #0 on atapci0
> ata3: channel #1 on atapci0
>
>
> _______________________________________________
> freebsd-stable at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-stable
> To unsubscribe, send any mail to "freebsd-stable-unsubscribe at freebsd.org"
>


--
Joao Barros