Problems with Rhine III card

[Thomas Nystrom]

Par Leijonhufvud wrote:
> 
> On Wed, 19 Nov 2003, Thomas Nystrom wrote:
> 
> > > /kernel: vr0: <VIA VT6105 Rhine III 10/100BaseTx> port 0x6400-0x64ff mem 0xe1000000-0xe10000ff irq 10 at device 11.0 on pci0
> > > /kernel: vr0: Ethernet address 00:05:5d:93:5b:61
> > > /kernel: miibus0: <MII bus> on vr0
> >
> > It should have said someting about ukphy0: bla-bla on miibus0 also,
> > right?
> 
> ukphy0: generic IEEE 802.3a media interface on miibus0
> ukphy0: 10baseT, 10baseT-FDX,100baseTX,100baseTX-FDX,auto
> 
> > What does an 'ifconfig vr0' say?
> 
> vr0: flags8843<UP,BROADCAST,RUNNING,SIMPLEX,MULTICAST> MTU 1500
> inet 213.132.119.242 netmask Oxffffff00 broadcast 213.132.119.255
> inet6 fe80::205:5dff:fe93:5b61%vr0 prefixlen 64 scopeid 0x1
> ether 00:05:5d:93:5b:61
> media: Ethernet autoselect (100baseTX <full-duplex>)
> status: active
> 

That seems OK, but: Where did you get that IP-address from? Why do you
start dhclient if you already have an address?

What do you have in your /etc/rc.conf (network_interfaces, ifconfig_*
and defaultrouter is the most interesting variables)?

/thn

-- 
---------------------------------------------------------------
Svensk Aktuell Elektronik AB                     Thomas Nyström
Box 10                                    Phone: +46 8 35 92 85
S-191 21  Sollentuna                        Fax: +46 8 35 92 86
Sweden                                      Email: thn at saeab.se
---------------------------------------------------------------