jumping to kernel entry at 0xc0048000 error on boot cd for
marius at alchemy.franken.de
Thu Dec 1 17:26:20 GMT 2005
On Thu, Dec 01, 2005 at 09:53:21AM -0600, Mario Beltran wrote:
> I want to install freebsd 6.0 for my Sun enterprise 220R but I cant.
> I downloaded two iso files from:
> On booth cds the installation stops in the same step. The complete
> message is:
> Sun Enterprise 220R (ultrasparc - II 450 MHz), keyboard present
> OpenBoot 3.23 1024 MB memory installed, serail #12050420.
> Ethernet address8:0:21:b7:df:d2, Host ID: 80b7dff2
> Initializing memory
> ok boot cdrom
> boot device: /pci at 1f,4000/scsi at 3/disk at 6,0:f file and argrs:
> >>FreeBSD/sparc64 boot block
> boot path: /pci at 1f,4000/scsi at 3/disk at 6,0:f
> boot loader: /boot/loader
> consoles: open firmware console
> boot path set to /pci at 1f,4000/scsi at 3/disk at 6,0:a
> FreeBSD/sparc64 bootstrap loader, revision 1.0
> (root at s-dallas.cse.buffalo.edu, wed nov 2 09:45:36 UTC 2005)
> bootpath="/pci at 1f,4000/scsi at 3/disk at 6,0:a"
> loading /boot/defaults/loader.conf
> /boot/kernel/kernel data=0x456608+0x5bfa8 syms=[0x8+0x60bd0+0x8+0x511b9]
> hit [enter] to boot inmediately, or any key for command prompt.
> booting [/boot/kernel/kernel]...
> nothing to autoload yet.
> jumping to kernel entry at 0xc0048000
> And that is all the system never pass from jumping to kernel entry at
> Is this an issue?
> Is this a bug?
> What should I do for solve this problem and install freebsd 6.0 in this
You're probably trying to use a not yet supported graphics card.
Either plug in a supported one, for the E220R you're only choices
so far probably are Sun PGX (aka Sun PGX8) and Sun PGX64 as AFAIK
the chassis doesn't allow to use the UPA slots, or use the serial
This mail was scanned by AntiVir Milter.
This product is licensed for non-commercial use.
See www.antivir.de for details.
More information about the freebsd-sparc64