Qlogic FC scsi_target ISP2310

Fuujin Networks LLC erich at fuujinnetworks.com
Wed Aug 27 03:13:50 UTC 2008


I've run into a snag with our SAN and I'm hoping someone out there can 
shed some light on the glass, as it were. We're trying to use 
scsi_target mode with a pair of QLogic ISP2310 2GB fibre-channel cards 
in a Point-to-Point topology. These cards will NOT be part of a switch 
fabric. I started out with a quad port card, and when I rescanned the 
SCSI bus on the initiating end of the loop, the target machine tanked.
The filer dumps core, reboots, and reproduces the result faithfully.

Thinking I might be doing something wrong with port selection, I pulled 
the quad port card out of the SAN filer and installed a single port 
card. After several days of jiggery pokery with all manner of knobs, 
AIO, etc, I've ended up with the same result: a 64-bit space heater. :)

I've Googled this to death, crawled the lists, and I've not found a 
solution other than the occasional "it might be buggy" comment. Full 
kernel traces are available to anyone interested, possibly even ssh 
access to a test box if requested. I've been running FreeBSD for about 7 
years and I've never seen an operating system as stable, so I'm rather 
determined to make this work than go to Linux.

The filer is running FreeBSD 7.0 amd64, dual Opteron 2216's, with 8 gigs 
of ram. I've tested this on a pair of HP DL580 G3's to see if there was 
a difference from 32-bit to 64-bit hardware, but none was apparent.

Any help is greatly appreciated!


-- 
Erich M. Jenkins
Fuujin Networks, LLC
PO Box 792
Brainerd, MN 56401
(p) 218-824-5038
(f) 218-824-7516

"You should never, never doubt what no one is sure about."
--Gene Wilder


More information about the freebsd-scsi mailing list