Access my digital camera via USB

[Warren Block]

On Tue, 14 Apr 2015, William A. Mahaffey III wrote:

>
>
> I am trying to get some photos off of my digital camera via USB cable. WHen I 
> plug it in, I get the following in my messages file:
>
>
> Apr 14 14:44:44 kabini1 kernel: ugen3.2: <SAMSUNG> at usbus3
> Apr 14 14:44:44 kabini1 kernel: umass0: <SAMSUNG Samsung Digital Camera, 
> class 0/0, rev 2.00/0.00, addr 2> on usbus3
> Apr 14 14:44:44 kabini1 kernel: umass0:  8070i (ATAPI) over Bulk-Only; quirks 
> = 0x4100
> Apr 14 14:44:44 kabini1 kernel: umass0:4:0:-1: Attached to scbus4
> Apr 14 14:44:44 kabini1 kernel: da0 at umass-sim0 bus 0 scbus4 target 0 lun 0
> Apr 14 14:44:44 kabini1 kernel: da0: <Samsung Digital Camera > Removable 
> Direct Access SCSI-0 device
> Apr 14 14:44:44 kabini1 kernel: da0: Serial Number E00000000002
> Apr 14 14:44:44 kabini1 kernel: da0: 40.000MB/s transfers
> Apr 14 14:44:44 kabini1 kernel: da0: 2909MB (5959296 512 byte sectors: 255H 
> 63S/T 370C)
> Apr 14 14:44:44 kabini1 kernel: da0: quirks=0x2<NO_6_BYTE>
> Apr 14 14:44:44 kabini1 kernel: GEOM_PART: integrity check failed (da0, MBR)

Look at that last line.  Probably no slices will be visible until the 
integrity problem is fixed.  This could be due to the camera firmware, 
and the card might work in a separate card reader.  Or it could be an 
actual problem with the MBR on the card.  I think there is a sysctl to 
disable integrity checking, but that is a workaround, not a solution.