rtadvd.conf with multiple addresses -> getconfig errors

[krad]

at worst case could you not fudge it by creating a tap interface and adding
that the config with the 2nd address, then bridge that interface onto your
physical nic? Ugly I know but it may get you out of a pickle if you are
pushed.

On 22 September 2014 15:37, Mike. <the.lists at mgm51.com> wrote:

>
>
> On 9/22/2014 at 2:16 PM krad wrote:
>
> |shouldnt it be more like?
> |
> |em1:\
> |:addrs#1:addr="2001:xxx:xxx:xxx::":prefixlen#64:tc=ether::rdnss="2001
> :xxx:
> |xxx:xxx::100"    :addrs#2:addr="2001:xxx:xxx:xxx
> |::":prefixlen#64:tc=ether::rdnss="2001:xxx:xxx:xxx::100"
> |
>
>
> Thanks for the suggestion.  Unfortunately, while there was no error
> message in the log, that syntax did not give me two working prefix
> advertisements.  When I run rtadvctl, only one of the two prefixes is
> shown as being advertised.
>
>
> I did find this old message thread:
>
> http://lists.freebsd.org/pipermail/freebsd-net/2012-February/031526.ht
> ml
>
> which suggests yet another syntax.  I tried the syntax in that
> message thread, and it advertised the two prefixes, but I still see
> the getconfig error message in the log.
>
>
> So I'm back where I started.
>
>
>
>
>
> _______________________________________________
> freebsd-questions at freebsd.org mailing list
> http://lists.freebsd.org/mailman/listinfo/freebsd-questions
> To unsubscribe, send any mail to "
> freebsd-questions-unsubscribe at freebsd.org"
>