Gateway load balance
Wojciech Puchar
wojtek at wojtek.tensor.gdynia.pl
Thu Jun 18 19:04:31 UTC 2009
>>
>> use ipfw and fwd command.
>>
>> for example with output section
>>
>> add 10000 fwd gw1_IP from DSL1_subnet to any via gw1_ethernet
>> add 10001 fwd gw2_IP from DSL2_subnet to any via gw2_ethernet
>> add 10002 fwd gw3_IP from DSL3_subnet to any via gw3_ethernet
>
> for my scenario I asume gwX_IP the IP address of my dsl gateways. What would
> be DSLX_subnet and gwX_ethernet?
sorry i thought you are not doing nat in gateways. if you do and cat
change it - change it, but it's not a requirement.
replace DSL1_subnet with DSL1_outgoing address etc., if all
gateways are connected by switch replace gw*_ethernet with the same.
you must start with different outgoing addresses (simple in squid) for
each gateway.
More information about the freebsd-questions
mailing list