6.2 Headless Installs Don't Seem to Work.

[Martin McCormick]

	I posted the original message about the 6.2 headless
installs. I tried again on an IBM Netfinity server with SCSI
drives today and here is the last screen of boot messages from
the CDROM burned from the 6.2 ISO image:

sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Timecounter "TSC" frequency 996849208 Hz quality 800
Timecounters tick every 1.000 msec
md0: Preloaded image </boot/mfsroot> 4423680 bytes at 0xc0af6544
acd0: CDROM <CRN-8241B/1.25 b> at ata0-master PIO4
Waiting 5 seconds for SCSI devices to settle
ses0 at ahc0 bus 0 target 8 lun 0
ses0: <IBM FTlV1 S2 0> Fixed Processor SCSI-2 device
ses0: 3.300MB/s transfers
ses0: SAF-TE Compliant Device
da0 at ahc0 bus 0 target 0 lun 0
da0: <IBM-PSG DDYS-T09170M  M S9HA> Fixed Direct Access SCSI-3 device
da0: 160.000MB/s transfers (80.000MHz, offset 63, 16bit), Tagged Queueing Enable
d
da0: 8678MB (17774160 512 byte sectors: 255H 63S/T 1106C)
da1 at ahc0 bus 0 target 1 lun 0
da1: <IBM-ESXS DTN036C1UCDY10F S23J> Fixed Direct Access SCSI-3 device
da1: 160.000MB/s transfers (80.000MHz, offset 127, 16bit), Tagged Queueing Enabl
ed
da1: 34715MB (71096640 512 byte sectors: 255H 63S/T 4425C)
Trying to mount root from ufs:/dev/md0

________________________________________________________________________________

	This is always the last message before a hard lockup at
which time the party is over. If we reboot and do not do the
headless install, the installation works properly.

Martin McCormick WB5AGZ  Stillwater, OK 
Systems Engineer
OSU Information Technology Department Network Operations Group