Error installing plone

[Erik Cederstrand]

Monah Baki wrote:
> Hi all,
> 
> I'm trying to install on Freebsd 6.3 plone from ports. I keep geting the
> error message
> 
> libtool: link: `gscanner.lo' is not a valid libtool object
> gmake[4]: *** [libglib.la] Error 1
> gmake[4]: Leaving directory
> `/usr/ports/devel/pkg-config/work/pkg-config-0.22/glib-1.2.8'
> gmake[3]: *** [all-recursive] Error 1
> gmake[3]: Leaving directory
> `/usr/ports/devel/pkg-config/work/pkg-config-0.22/glib-1.2.8'
> gmake[2]: *** [all] Error 2
> gmake[2]: Leaving directory
> `/usr/ports/devel/pkg-config/work/pkg-config-0.22/glib-1.2.8'
> gmake[1]: *** [all-recursive] Error 1
> gmake[1]: Leaving directory
> `/usr/ports/devel/pkg-config/work/pkg-config-0.22'
> gmake: *** [all] Error 2
> *** Error code 2
> 
> Stop in /usr/ports/devel/pkg-config.
> *** Error code 1
> 
> Stop in /usr/ports/x11/xproto.
> *** Error code 1
> 
> Stop in /usr/ports/x11/libXau.
> *** Error code 1
> 
> Stop in /usr/ports/x11/libX11.
> *** Error code 1
> 
> Stop in /usr/ports/x11-toolkits/tk84.
> *** Error code 1
> 
> Stop in /usr/ports/x11-toolkits/py-tkinter.
> *** Error code 1
> 
> Stop in /usr/ports/graphics/py-imaging.
> *** Error code 1
> 
> Stop in /usr/ports/graphics/py-imaging.
> *** Error code 1
> 
> Stop in /usr/ports/www/plone.

This is more a workaround than a solution, but you don't need the X11 
libraries to run plone. Try putting "WITHOUT_X11=yes" in your make.conf.

Erik